Elephant SUPER DENSE LOOP-LOC MESH Maintenance manual
THECARE&MAINTENANCEOFYOUR
SUPERDENSEMESHORAQUA-XTREMEMESH
LOOP-LOCSWIMMINGPOOLCOVER
By following the simple instructions listed below, you can insure maximum performance of your LOOP-LOC MESH
Swimming Pool Cover for the years to come. The cover will have no problem supporting the weight of a child or an adult in
the case of an emergency. However, we do not recommend walking on it and never allow children or pets to play on top of
the cover. Adult supervision is always required around any swimming pool area.
INSTALLATION: LOOP-LOC Safety Covers should be measured and installed by a swimming pool professional to
maintain all safety features and your pro-rated warranty.
TIGHTNESS: Most important is that your LOOP-LOC cover be installed - and remain - tightly stretched across your pool,
resembling a trampoline. Upon its original installation, the adjustable springs on your LOOP-LOC cover should be
compressed about 90% for IN-GROUND and about 50% for ON-GROUND. The tension will gradually decrease in time,
adjust as needed to maintain 75% compression for Inground and 50% compression for ON-Ground.
SNOW
SUPPORT:During the snow season, the water level in your pool should be kept approximately 15” to 18” below
the top of the pool for IN-GROUND and 14” below the top of the pool for ON-GROUND. This is important for supporting
the weight of the snow on the cover. Allowing the water level to drop below 18” for IN-GROUND and 14” for ON-GROUND
will put excess stress on the cover and will void your warranty.
PERIODIC
MAINTENANCE: It is important to periodically check your LOOP-LOC Swimming Pool Cover to insure
mazimum performance in regards toASTM guidelines. For example, in rare instances if non-warranty factors such as tree
limbs, animals, etc. cause a tear or rip in the fabric, it may result in the cover not being able to support the ideal weight to
meet the guidelines. All covers should be periodically checked for pre-mature U.V. deterioration which can void the safety
features of the cover. Please contact your local swimming pool dealer if you have any questions or to have your cover
repaired immediately. Please note: If your cover is a safety cover and is in need of repair, it will not be considered safe
and will not meetASTM guidelines until the work is performed.
COVER
REMOVAL/STORAGE:
Prior to removing your cover, hose it off while it is still installed across the pool, to
remove any debris that has collected on top.
When removing your LOOP-LOC, accordian-fold it and roll it into its storage bag. Hang the bag on a hook or nail (off
the floor) to allow the cover to drain through the bag and to protect it from rodents.
As with any valuable, high quality product, care should be exercised when installing or removing your LOOP-LOC.
Dragging the cover across the deck, over sharp edges or obstructions, or over raised anchor or bracket heads will damage
the cover.
ANCHORS
FOR
IN-GGROUND
COVERS: In the spring and fall, remove all anchors and flush out all anchor
casings with a hose. This will prevent anchors from sticking when you re-install them.
When the cover is not in use, close the anchors completely, so they are flush with the deck. This will eliminate the
possibility of stubbed toes.
WINTER
CHEMICAL
TREATMENT:
For pool water to remain clear it must have proper levels of sanitizer and
algaecide at all times - regardless of whether the pool is in use. Remember: a LOOP-LOC cover keeps out debris,
but ONLY proper chemicalization can keep your pool water clear, clean and safe.
When closing your pool in the fall, we recommend the use of a winterizing chemical kit, which includes winterizing
algaecide. Contact your dealer for information on additional winter sanitizers appropriate for your pool, i.e. gunite or
vinyl. When winterized properly, spring clean up will be kept at a minimum.
One month before opening your pool, or when temperatures of 60 degrees or higher remain constant, additional
algaecide should be added to the pool. Periodic additions of sanitizer may be needed to maintain proper water
chemistry and reduce algae growth.
Automatic cleaners may be used underneath your LOOP-LOC cover.
IMPORTANT
HOMEOWNER
SPECIAL
INSTRUCTIONS: LOOP-LOC covers not only meet, but exceedASTM
standards for Safety Swimming Pool Covers F1346-91. To show our commitment and dedication to the safety and
security of your family, LOOP-LOC covers have undergone extensive outside testing through Underwriters
Laboratories (U.L.) and have earned the seal of approval for safety swimming pool covers. Contact with sharp
hooved animals will cause damage.
SWIMMING
POOL
COVER
TECHNICAL
NOTE
FOR
PAINTED
ALUMINUM
&
PLASTIC
CONCRETE
RECEPTOR
COPING: If LOOP-LOC water levels, tensioning requirements and padding recommendations are not
followed, pools with painted aluminum or plastic concrete receptor coping may be marred.Also, if you are in a high
wind area it is imperative to utilize additional padding or LOOP-LOC'S Coping Protector Caps to prevent marring. If
you know these conditions exist, or have the coping types above please contact your dealer to order LOOP-LOC'S
undercover padding or LOOP-LOC'S Coping Protector Caps.
**FOR
ON-GGROUND
POOLS:
Due to variations in skimmer and return locations, the use of winterizing plug and
plate may be required. It is important that you check the pool manufacturer’s winter instructions for any special
recommendations regarding safety covers.
Loop-Loc
390 Motor Parkway
Hauppauge, NY 11788
1-800-562-5667
In NY State 631-582-2626
Fax#: 631-582-2636 www.looploc.com
This manual suits for next models
1
Table of contents
Popular Lighting Equipment manuals by other brands
Qazqa
Qazqa Suplux SL 3 Black 103062 instruction manual
Commercial Electric
Commercial Electric 54568141 Use and care guide
CREE LIGHTING
CREE LIGHTING 304 Series installation instructions
Goobay
Goobay 49867 user manual
ECOMAN ITALIA
ECOMAN ITALIA LED T8 instruction manual
Alkalite
Alkalite Krypton KT-81 user manual
