Electrolux 318202107 User manual

Service Manual

Warmer Drawer

318 202 107 (0311)

THIS IS A

BLANK

PAGE

Table of Contents

SAFE SERVICING PRACTICES .......................................... 1

WIRING DIAGRAM............................................................... 2

SECTION A - INSTALLATION INSTRUCTIONS ................. 3

FOR YOUR SAFETY .......................................................................................................... 3

WARM & SERVE DRAWER DIMENSIONS ........................................................................ 3

IMPORTANT NOTES TO THE INSTALLER ........................................................................ 4

IMPORTANT NOTE TO THE CONSUMER ......................................................................... 4

IMPORTANT SAFETY INSTRUCTIONS ............................................................................. 4

TOOLS YOU WILL NEED ................................................................................................... 4

WARM & SERVE DRAWER INSTALLATION ..................................................................... 5

SECTION B - REPLACEMENT OF PARTS ......................... 6

1.0 HOW TO REMOVE THE DRAWER FROM THE DRAWER CAVITY ........................ 6

2.0 HOW TO RE-INSTALL THE DRAWER ..................................................................... 6

3.0 HOW TO REMOVE THE APPLIANCE FROM THE CABINET .................................. 6

4.0 HOW TO REMOVE PANELS TO HAVE ACCESS TO THE PARTS .......................... 7

5.0 HOW TO REPLACE THE ELECTRICAL CORD ....................................................... 8

6.0 HOW TO REPLACE THE WARMER DRAWER ELEMENT ...................................... 8

7.0 HOW TO REPLACE THE THERMOSTAT ................................................................. 9

8.0 HOW TO REPLACE THE WARMER DRAWER CONTROL ..................................... 9

9.0 HOW TO REPLACE THE SLIDING CHANNELS .................................................... 10

SECTION E - EXPLODED VIEW DRAWINGS................... 12

BODY EXPLODED VIEW ................................................................................................. 12

BODY PARTS DESCRIPTION .......................................................................................... 13

DRAWER EXPLODED VIEW ............................................................................................ 14

DRAWER PARTS DESCRIPTION .................................................................................... 15

THIS IS A

BLANK

PAGE

SAFE SERVICING PRACTICES

To avoid personal injury and/or property damage, it is important that Safe Servic-

ing Practices be observed. The following are some limited examples of safe

practices:

1. DO NOT attempt a product repair if you doubt your ability to complete it in a

safe and satisfactory manner.

2. Before servicing or moving an appliance:

• Remove power cord from electrical outlet, trip circuit breaker to the OFF

position, or remove fuse.

• Turn off gas supply

• Turn off water supply

3. Never interfere with the proper operation of any safety device.

4. Use The Correct Replacement Parts Cataloged For This Appliance. Sub-

stitutions May Defeat Compliance With Safety Standards Set For Home

Appliances.

5. GROUNDING: The standard color code for safety ground wires is GREEN, or

GREEN with YELLOW STRIPES. DO NOT use ground leads as current

carrying conductors. It is EXTREMELY important that the service technician

reestablish all safety grounds prior to completion of service. Failure to do so

will create a hazard.

6. Prior to returning the product to service, ensure that:

• All electrical connections are correct and secure.

• All electrical leads are properly dressed and secured away from sharp edges,

high-temperature components, and moving parts

• All non-insulated electrical terminals, connectors, heaters, etc. are ad-

equately spaced away from all metal parts and panels

• All safety grounds (both internal and external) are correctly and securely

connected

• All panels are properly and securely reassembled

WARNINGWARNING

WARNING

This service manual is intended for use by persons having electrical and mechanical

training and a level of knowledge of these subjects generally considered acceptable in the

appliance repair trade. Electrolux Home Products cannot be responsible, nor assume any

liability, for injury or damage of any kind arising from the use of this manual.

2Wiring Diagram

Section A - Installation Instructions

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

GENERAL INFORMATION

The Warm & Serve Drawer can be used:

• As a stand alone appliance

• As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above

IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front and the

surface must be capable of supporting 100 lbs (45 Kg).

Warm & Serve Drawer Dimensions

Stand Alone Installation

Combination Warm & Serve Drawer/

30" (76 cm) Built-in Oven Installation

NOTE: A 60" (152 cm) long cable is supplied with

the Warm & Serve Drawer.

A. HEIGHT B. WIDTH C. DEPTH

9 7/8 " (25 cm) 30" (76,2 cm) 24 5/8" (62,5 cm)

D. CUTOUT E. CUTOUT F. CUTOUT

HEIGHT WIDTH DEPTH

Min. 8 3/8" (21,3 cm) 28 1/2 " (72,4 cm) 24" (61 cm)

Max. 8 5/8" (21,9 cm) 28 3/4 " (73 cm)

D. CUTOUT E. CUTOUT F. CUTOUT G. HEIGHT

HEIGHT WIDTH DEPTH

Min. 8 3/8" (21,3 cm) 28 1/2 " (72,4 cm) 24" (61 cm) 1 1/2" (3,8 cm)

Max. 8 5/8" (21,9 cm) 28 3/4 " (73 cm)

IMPORTANT: The Warm & Serve Drawer runs off a

single phase three-wire 120 volt, 60 hertz, AC only

electrical supply with ground.

H* =10 1/8" (25.7 cm) Min. is a Critical

dimension and has to be respected.

Depends on critical

dimension H

A. HEIGHT B. WIDTH C. DEPTH

40" (101,5 cm) 30" (76,2 cm) 24 5/8" (62,5 cm)

FLOOR

Warm and Serve

Cutout

Warm and Serve

Drawer

60" (152 cm)

Cord

Minimum distance to

floor 41/2" (11,4 cm)

Bottom of oven cutout

Caution: Two 3" wide X 3/4"

(1.9 cm) thick planks have to

be install and they should be

able to support 200 pounds.

(90.7 Kg)

4Section A - Installation Instructions

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing appliance.

2. Remove all packing material from appliance before

connecting the electrical supply.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions for future reference.

IMPORTANT SAFETY

INSTRUCTIONS

•Be sure your appliance is installed and plugged

into a 120 Volt grounded outlet.

•This appliance must be electrically grounded in

accordance with the National Electrical Code

ANSI/NFPA No. 70—latest edition in the United

States, or CSA C22.1, Part 1 in Canada, and local

code requirements.

Tools You Will Need

Phillips® Screwdriver

Pencil

Ruler or Tape Measure and Straight-edge

Hand Saw or Saber Saw

Spirit Level

Figure 1

c/c 25 5/16"

(64.3 cm)

24" (64.3 cm) Max.

23 5/8" (60 cm) Min.

c/c 12 21/32"

(32.15 cm)

Section A - Installation Instructions

Warm & Serve Drawer Installation

1. Locate the 2 anti-tip brackets supplied as shown on

figure 1.

2. Slide drawer into cutout opening until front frame of

drawer is flush against cabinet. Be careful not to

pinch electrical cord.

3. Remove the drawer as instructed in the Use & Care

Guide and secure drawer housing to cabinet using

the 2 nickel-plated screws supplied (see Figure 2).

Do not overtighten screws.

4. The 60" (152 cm) appliance power cord can now be

connected into the 120 Volt outlet.

5. Proceed with mounting built-in oven above the

drawer (if applicable). Follow installation instructions

provided with built-in oven. Make sure to use anti-

tip brackets supplied with the built-in oven.

Figure 2

Use screws

supplied to attach

drawer to front

of cabinet.

6Section B - Replacement of parts

1.0 HOW TO REMOVE THE DRAWER FROM THE DRAWER CAVITY

1. Disconnect Warmer Drawer from electrical supply.

2. Make sure the drawer is COOL. Open the drawer to the

fully opened position

3. Locate the latches on both sides of the warmer drawer.

Push at the same time on both latches while pulling the

drawer out. (Figure 1)

Figure 1

2.0 HOW TO REINSTALL THE DRAWER

1. Align the glide latches on both sides of the drawer with slots on the drawer.

2. Push the drawer back in until you heard two clicks which will indicate that

the drawer is well installed.

3.0 HOW TO REMOVE THE APPLIANCE FROM THE CABINET

1. Disconnect Warmer Drawer from electrical supply.

2. Remove the drawer from the drawer cavity. (Section 1.0)

3. Remove the 2 screws securing the warmer drawer to the cabinet.

4. Pull out the appliance from the cabinet.

Table of contents

Other Electrolux Warming Drawer manuals

Electrolux

Electrolux E30WD75DSS1 User manual

Electrolux

Electrolux E30WD75GPS3 User manual

Electrolux

Electrolux 318 201 016 User manual

Electrolux

Electrolux E30WD75EPS User manual

Electrolux

Electrolux ICON E39WD75GTT User manual

Electrolux

Electrolux EED 14700 User manual

Electrolux

Electrolux 318 201 017 User manual

Electrolux

Electrolux WARM & SERVE DRAWER User manual

Electrolux

Electrolux WARMER DRAWER User manual

Electrolux

Electrolux WARMER DRAWER User manual

Electrolux

Electrolux 318201808 User manual

Electrolux

Electrolux Icon E30WD75GSS User manual

Electrolux

Electrolux E30WD75ESS2 User manual

Electrolux

Electrolux EED29600X User manual

Electrolux

Electrolux E30WD75EPS3 User manual

Electrolux

Electrolux 318 201 018 User manual

Electrolux

Electrolux EWD1402DSE User manual

Electrolux

Electrolux 318201810 User manual

Electrolux

Electrolux E30WD75EPS Instruction Manual

Electrolux

Electrolux E30WD75EPS User manual

Electrolux

Electrolux EW27WD55GS3 User manual

Electrolux

Electrolux WARM & SERVE DRAWER User manual

Electrolux

Electrolux 318201811 User manual

Electrolux

Electrolux EWD1402DSD User manual

Popular Warming Drawer manuals by other brands

Siemens

Siemens HW 290 Series instruction manual

Hatco

Hatco HDW-1 Installation & operating manual

APW Wyott

APW Wyott WD-2CMF Specification sheet

Viking

Viking DEWD102SS Quick reference guide

Miele

Miele ESW 6229 Operating and installation instructions

Brandt

Brandt WD1014X user guide

KitchenAid

KitchenAid KOWT107ESS installation instructions

Gaggenau

Gaggenau WSP 222 installation instructions

DCS

DCS WDI installation guide

Fisher & Paykel

Fisher & Paykel OR90SCG6R1 manual

Fisher

Fisher PROFESSIONAL WB76SPEX1 user guide

Hanseatic

Hanseatic TCN14J6D-S user manual

Jenn-Air

Jenn-Air JWD6030CDX user guide

Gaggenau

Gaggenau WS482710 installation instructions

Bosch

Bosch HWD2720UC installation manual

NEFF

NEFF N29HA11Y2 User manual and installation instructiions

Fisher & Paykel

Fisher & Paykel WB60SMTB1-SET Quick reference guide

Bull

Bull W85747 instruction manual