Please carefully read these instructions as they include
valuable information for installation, operation and
maintenance of this device
Warning
Keep this manual for future consultations. f you resell your moving head to an other
individual, make sure to also give him this manual.
Unpack and carefully check that the moving head didn’t take any damages during the
transport before using it.
Before any connection, make sure that both the voltage and the frequency of your power
source match your moving head specifications.
Check your device as well as your equipment’s grounding.
This device is only meant for indoor use ; protect it from heat and humidity (allowed
ambient temperature from 10 to 40°C).
The moving head must be set up in a ventilated area, at least 50cm away from any adjacent
surface. Check that no ventilation hole is blocked.
Unplug the moving head’s power source before any maintenance or handling operation.
Only replace the fuse by a fuse of the same type.
n order to avoid any fire hazard, check for any flammable source nearby.
Use safety cables to secure the moving head. Hold the moving head only by its carrying
handles to avoid degradation and risk of injury.
Switch off the power and let the moving head cool down for about 15 minutes before
transport, for the moving head’s surface may be hot still.
n the event of a serious functioning problem, stop immediately to use the device. Do no
ever try to repair the device by yourself. Repairs made by unqualified individuals may
cause damages or malfunctions. Contact the nearest approved technical support center.
Always use spare parts of the same type.
Do not ever touch the led with your bare fingers after use to avoid serious injuries, for the
led may be very hot still.
Do not start the moving head without led to avoid degradation of the box..
Replace the box and the lenses if they are visually damaged (for example cracks or
deep cuts during transport or handling). This is essential.
Do not look straight at the light going out of led when the moving head is switched on.
n order to prevent any risks of electrical shock you must not remove the cover. There is no
useful part for the user inside. Refer the repair to qualified personnel.
Installation
