ELAD ASA-16 User Manual Rev 2 - 10/2019
© 2019 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated
in any form or by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
2
Connections and operations
Power supply.
To power on the device simply connect a 12V DC –300 mA power supply with the power
connector on the rear panel of the ASA-16. The power status is indicated by the ON Led on the
front panel.
Input connection.
Connect the receiving antenna cable with the Input 50 Ohm BNC Coax connector located on the
rear panel.
Output connections.
Connect each one of the receivers with one of the Output 50 Ohm BNC Coax connectors
labeled 1 to 6 located on the rear panel.
Input attenuator.
A 15dB attenuator can be inserted on the input line by operating the related switch on the front
panel. The INPUT led will light on to indicate the insertion of the attenuator.
Output off.
The OUTPUT OFF led will light on when the PTT input on the rear panel is connected to
ground. The PTT input is a 3.5 mm stereo jack connector.
The PTT line is on the TIP signal.
Packaging
The package includes :
- the ASA-16 device,
- a cable for the PTT connection,
- the 12V connection cable, 2.1mm DC plug to open end,
- this printed user manual.
Note : the package do not includes power supply.
