2
PE-Conductor Tester 2GA27 90-2A
Description
Table of contents
A DESCRIPTON OF FRONT PANEL CONTROLS ....................................3
1 INTRODUCTION......................................................................................5
1.1 GENERAL INFORMATION .....................................................................5
1.2 ABBREVIATIONS AND SYMBOLS ........................................................ 6
1.3 SHORT DESCRIPTION OF THE PE CONDUCTOR TESTER ................ 6
1.4 GENERAL DATA..................................................................................... 7
1.5 NAME PLATES ....................................................................................... 7
2 SAFETY REGULATIONS ........................................................................8
2.1 SIGNS OF SAFETY AND WARNING REGULATIONS ...........................8
2.2 WARRANTY ............................................................................................ 8
2.3 USE AS PER SPECIFICATIONS AND EXCLUSION OF LIABILITY ...... 8
2.4 GENERAL RULES OF CONDUCT AND SAFETY REGULATIONS ....... 9
2.5 PARTICULAR REFERENCES TO THE PE CONDUCTOR TESTER.... 10
3 PUTTING INTO OPERATION................................................................ 11
3.1 TRANSPORT AND INSTALLATION ..................................................... 11
3.2 CONNECTION ....................................................................................... 11
3.3 SETTING THE TEST UNIT PARAMETERS .......................................... 12
4 OPERATING MODES............................................................................ 14
4.1 MEASURING PRINCIPLE ..................................................................... 14
4.2 PE CONDUCTOR TEST WITHOUT THREE-WIRE PLUG .................... 15
4.3 TEST VIA THREE-WIRE PLUG............................................................. 16
4.4 TEST WITH TEST PROBE (SO)............................................................ 17
4.5 OPERATION IN COMBINATION WITH AN INSULATION
TESTER....................................................................................... 18
5 OPERATION VIA INTERFACE.............................................................. 19
5.1 PIN ASSIGNMENT OF INTERFACE TERMINAL STRIP (X7)............... 19
5.2 TERMINAL ASSIGNMENT OF THE 11-PIN VG
CONNECTOR (X1) ...................................................................... 21
5.3 TERMINAL ASSIGNMENT OF THE TERMINAL BLOCK (X6) .................
6 FAULT INDICATIONS ........................................................................... 22
7 MAINTENCANCE AND ATTENDANCE ................................................ 23
7.1 EXCHANGE OF FUSES ........................................................................ 23
7.2 SERVICE OF THE HOUSING................................................................ 24
8 TECHNICAL DATA ............................................................................... 25
9 APPENDIX............................................................................................. 26
9.1 COMPONENT LOCATION ILLUSTRATION OF .......................................
SUBASSEMBLY PE100 .............................................................. 27
9.2 COMPONENT LOCATION ILLUSTRATION OF .......................................
SUBASSEMBLY PEIS200........................................................... 28
9.3 WIRING DIAGRAMM............................................................................. 30
