Edimax ES-3124REM User manual
24-Port Ethernet
Management Switch
(VLAN, Trunking, QoS)
ES-5224RM
ES-5224REM
ES-5224RFM
ES-3124REM
User’s Manual
2
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the
limits of a Class A computing devices, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
If you suspect this product is causing interference, turn your
computer on and off while your radio or TV is showing
interference. If the interference disappears then when you turn
the computer off and reappears when you turn the computer on,
something in the computer is causing interference.
You can try to correct the interference by one or more of the
following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit difference
from that to which the receiver is connected.
4. Ensure that all expansion slots (on the back or side of the
computer) are covered. Also ensure that all metal retaining
brackets are tightly attached to the computer.
3
Content
Chapter1 Introduction
1. Introduction .........................................6
2. Features & Specifications ...................8
3. Package Contents............................... 10
4. Hardware Description....................... 11
Chapter 2 Web Management Function
1. Web Management Overview............. 13
2. Port Status.......................................... 15
3. Port Statistics ..................................... 17
4. Administrator .................................... 18
4.1 IPAddress..................................................18
4.2 Switch Settings ..........................................19
4.3 Console Port Information.........................22
4.4 Port Controls.............................................23
4.5 Trunking ....................................................25
4.6 Filter Database ..........................................28
4.7 VLAN configuration.................................31
4.8 Spanning Tree............................................36
4.9 Port Sniffer................................................38
4.10 SNMP .........................................................39
4.11 Security Manager......................................41
4
4.12 802.1X Configuration ...............................42
4.13 TFTP Update Firmware...........................45
4.14 Configuration Backup..............................46
4.15 Reset System..............................................47
4.16 Reboot ........................................................48
Chapter 3 Console-Menu Line
1. Main Menu......................................... 50
2. Switch Static Configuration.............. 51
2.1 Port Configuration..........................................52
2.2 Trunk Configuration.......................................54
2.3 VLAN Configuration......................................55
2.4 Misc Configuration.........................................61
2.5 Administration Configuration.......................65
2.6 Port Mirroring Configuration.......................68
2.7 Priority Configuration....................................69
2.8 MAC Address Configuration.........................70
3. Protocol Related Configuration ....... 72
3.1 STP ...................................................................72
3.2 SNMP ...............................................................75
3.3 GVRP ...............................................................80
3.4 IGMP................................................................81
3.5 LACP................................................................83
3.6 802.1X...............................................................86
4. Status and Counters .......................... 89
5
4.1 Port Status........................................................90
4.2 Port Counters..................................................91
4.3 System Information ........................................92
5. Reboot Switch .................................... 93
5.1 Default..............................................................93
5.2 Restart..............................................................93
6. TFTP Update Firmware.................... 94
6.1 TFTP Update Firmware.................................94
6.2 Update Configure File ....................................95
6.3 Upload Configure File ....................................97
6
Chapter 1 Introduction
1. Introduction
Congratulations on your purchase of this Fast/Gigabit Ethernet
Management Switch. This high performance management
switch provides Ethernet ports to segment network traffics,
extend Ethernet connection distance, and convert data packets
between different transmission speeds.
This switch utilizes stored-and-forward switching architecture
that filters and forwards data after the complete data packet is
received and examined to be free of errors. With one set of
status LEDs for each individual port, the switch operation status
can be easily monitored.
All the Fast Ethernet ports support both Full and Half duplex
mode which are able to provide up to 200Mbps(2000Mbps for
Gigabit Ports) of bandwidth to the connected devices, with
auto-negotiation providing the capability to connect to
100/10Mbps(1000/100/10Mbps for Gigabit ports) network
devices. It also supports backpressure and IEEE 802.3x
advanced flow control capabilities that can reduce congestion
and prevent packet loss.
And it offers advance features:
SNMP/Web-based Management: Provides a web browser
to manage and monitor the switch.
Bandwidth Control: Input and output rate control.
VLAN: Port-based and Tag-based VLAN allow you to set
virtual LANs within your network
Trunking: Reduce the bottleneck between switches
QoS: Two priority queues per port allow you to define
which port has higher priority.
802.1X: This switch supports port-based authentication
protocol, IEEE 802.1X.
7
In addition, all the ports support the MDI/MDI-X auto-detect
function. That is to say, you can connect any device (including
PC, Switch, Hub) to a port of this switch using a regular cable.
The RJ-45 port will auto-detect and auto-switch to the correct
MDI/MDI-X mode (do not need to use a specific uplink port or
cross-over cable).
8
2. Features & Specifications
Features
Complies with the IEEE802.3 Ethernet, IEEE802.3u Fast
Ethernet (IEEE802.3z, IEEE802.3ab for Gigabit switch)
Provides Store-and-Forward architecture and full wire
speed filtering and forwarding rates
10/100Mbps Ports support full/half duplex modes and
auto-negotiation
Provides two Fast Ethernet Modules option (Fast/Gigabit
Ethernet Management Switch):
♦ 100/10Mbps UTP connector (RJ-45)
♦ 100Mbps Fiber SC/ST connector (multi/single mode)
Provides two Gigabit Ethernet Modules option (Gigabit
Ethernet Management Switch only):
♦ 1000/100/10Mbps UTP connector (RJ-45)
♦ 1000Mbps Fiber SC connector (multi/single mode)
Supports flow control: back pressure for half-duplex mode,
IEEE 802.3x for full-duplex mode
Supports SNMP, Web-based, Telnet and Console
Management
MIB: MIBⅡ, Ethernet/Bridge MIB
RMON: 4 Groups (1,2,3,9)
Supports Port-based VLAN and IEEE802.1Q Tag-based
VLAN (up to 256 groups)
Supports Trunking: Up to 7 trunking groups
Supports Port Mirroring
Supports the Spanning Tree Protocol: IEEE 802.1D
19” rack mount size designed
9
Specifications
Standards: IEEE802.3, IEEE802.3u, IEEE802.3z,
IEEE802.3ab, IEEE802.1Q, IEEE802.1p
10/100Mbps Ports: RJ-45 ×24
Expansion Slot Option (Fast/Gigabit Ethernet Switch):
♦ 10/100Mbps UTP connector (RJ-45)
♦ 100M Fiber SC/ST connector (multi/single mode)
Expansion Slot Option (Gigabit Ethernet Switch only):
♦ 1000/100/10Mbps UTP connector (RJ-45)
♦ 1000Mbps Fiber SC connector (multi/single mode)
Console Port: DB9 ×1
Forwarding Method: Store-and-Forward
MAC Address: 14K
Buffer Memory: 512KBytes
Flow control: Back pressure for half-duplex and
IEEE802.3x for full-duplex
Auto-negotiation: All ports
Auto-MDI/MDI-X function: All ports
System LED indication: Power
Port LED indication:
LNK/ACT: Link / Activity
Speed: 10/100Mbps
Dimension: 45(H) ×445(W) ×170(D) mm
1.8(H) ×18(W) ×6.9(D) in
Weight: 2.45 Kg / 5.5 lb
Operation Temperature: 50~131℉(10~55℃)
Operation Humidity: 10~95% (Non-condensing)
Power: 100~240VAC, full range internal power supply
Emission: FCC Class A, CE, C-Tick
10
3. Package Contents
Packing list
Check the contents of your package for following parts:
One Fast/Gigabit Ethernet Management Switch
One User's manual
One Power cord
One RS-232 Cable
If any of the items are missing or damaged, please
contact your local dealer.
CONSOLE
24-port Fast/Gigabit Ethernet Management Switch
power
This manual suits for next models
3
Table of contents
Other Edimax Network Router manuals
Edimax
Edimax CV-7438nDM Reference guide
Edimax
Edimax CV-7438nDM User manual
Edimax
Edimax AR-7186WnA User manual
Edimax
Edimax Wireless Multi-Homing Broadband Router User manual
Edimax
Edimax AR-7167WnA User manual
Edimax
Edimax EW-7811Un V2 User manual
Edimax
Edimax BR-6258n Nano router User manual
Edimax
Edimax BR-6478AC User manual
Edimax
Edimax Wireless VPN Broadband Router User manual
Edimax
Edimax AR-7084gA/B User manual
Edimax
Edimax ER-1088 User manual
Edimax
Edimax 3G-6200nL V2 User manual
Edimax
Edimax EW-7822UAC User manual
Edimax
Edimax ES-1008PH Reference guide
Edimax
Edimax AR-7182WnA User manual
Edimax
Edimax BR-6104K User manual
Edimax
Edimax AR-7211A V2 User manual
Edimax
Edimax CV-7438nDM User manual
Edimax
Edimax GS-5208P User manual
Edimax
Edimax AR-7286WnA User manual
