V8.xQuick Start Guide
iPrism Secure Web Gateway
Your iPrism Installation is Now Complete
Step 4. Shut Down and Relocate the iPrism Appliance (If it is not already located in a production setting)
Ensure proper shut down and relocate the iPrism to a network or subnet that will be convenient for testing, typically near
your Internet gateway. Connect a network cable between your switch and the INTERNAL iPrism interface, and turn on the
power.
Step 3. Run the Installation Wizard
To complete the Installation Wizard you will need the setup data from Step 1 and your iPrism License Key le (should be
saved to your desktop). The following is an outline of the Installation Wizard steps:
3.1 Username and Password
The Wizard will prompt you for a user name and password. The defaults are Username: iprism; Password: setup
3.2 Agree to License
You will be prompted to accept the License Agreement. Read the agreement and click Agree to continue
3.3 New or Restore Cong
New Customers should select Start a new conguration and click Next to continue.
Existing customers can restore their settings from their backup by selecting Restore from archive and then
uploading their archive. Once that is completed the iPrism will shut down. Proceed to Step 4
3.4 Upload License Key
Browse to the location where you saved your iPrism License Key le, then click Next to continue.
3.5 Enter Registration Information
Enter your contact information. Choose carefully as your Administrator email is used for delivering important iPrism
product update information. It is recommended that you change your password by selecting Set Password.
3.6 Network Settings
Enter the setup data you recorded in Step 1. To enter the IP address for your DNS, click DNS Settings then Add in the
Name Servers pop-up window. Enter your DNS address and click OK to continue. Enter your IP address recorded in
Step 1.5. Select OK then Next to continue.
Note: Some of the values on this page are pre-populated, they can be changed.
3.7 Filter Settings
Specify whether to monitor and/or block Web and application trac, and select the iPrism time zone.
3.8 Review Settings
Review the conguration settings and click Apply. To make changes to any of the settings, click Back.
Note: You can only use the Print option with a local printer. Conguration reports will be available once you reboot.
3.9 iPrism will save and apply the settings and reboot automatically – this may take 4-5 minutes.
2.2 Go to your workstation, and point your browser to the IP address that you just gave iPrism, using port 80 (it will
redirect to the https port).
