eDecks Step Stringer User manual
Kit Contents
Don’t forget to check your work with a level as you go! Page 1 of 7
YOUR KIT WILL CONTAIN THE FOLLOWING ITEMS
This is an example of finished step kit,
please note these instructions are relevant
for all our step stringer kits
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
TRUSS CLIPS & FIXINGS STRINGERS DECKING BOARDS
Step 1
Don’t forget to check your work with a level as you go! Page 2 of 7
SET OUT YOUR STRINGERS
MAX 590
First make sure the ground is flat and level, then measure and place
your stringers at the desired width for your steps, please note the
maximum width we recommended is 590mm additional stringers
will be needed if you require a wider span.
As shown on the diagram opposite the rise on the stringers should be
9.5” and the step should be 8.5”, please make sure your stringers are
the correct way up.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
STEP
APPROX 8.5”
SIDE VIEW
RISE
APPROX 9.5”
Step 2
Don’t forget to check your work with a level as you go! Page 3 of 7
FIX STRINGERS INTO POSITION USING TRUSS CLIPS
x2
SPAX SCREWS
Secure the truss clips to your supporting surface and the step stringer
by using the twist nails into the 17 holes on the truss clips and 2 spax
screws as shown in diagram.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
x17
TWIST NAILS
Step 3
Don’t forget to check your work with a level as you go! Page 4 of 7
SECURE THE 2 BOTTOM BOARDS TO THE STRINGERS
Start by securing the lowest board to the base of the stringers, use 4
screws - 2 at each end of the board to secure the board in place.
Once in position secure the ripped down board in the same way,
leaving a 5mm gap between the lowest board.
Cont worry that the edge of the ripped down board will be visible at
this point it will get covered by the step boards in the next step.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
Leave a
5mm Gap
Step 4
Don’t forget to check your work with a level as you go! Page 5 of 7
SECURE THE FIRST 2 STEP BOARDS TO THE STRINGERS
Next position and secure the lowest step boards, start at the front so
that the deck board overhangs the stringer slightly and covers the
edge of the ripped down board fitted in previous step, the edge of
this board should be flush with the riser boards below, secure using 2
screws at each end.
Once in position place the second board behind the front board
leaving a 5mm gap, don’t worry if there is a small space where the
board meets the corner of the stringer this will be covered by the riser
boards in the next step.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
Leave a
t Gap
Step 5
Don’t forget to check your work with a level as you go! Page 6 of 7
SECURE THE REMAINING BOARDS TO THE STRINGERS
Repeat the previous 2 steps for the remainder of the boards until all
the steps have been completed.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
Finish
Don’t forget to check your work with a level as you go! Page 7 of 7
Once all the boards are fitted to the stringers your kit should look like
the diagram below.
www.eDecks.co.uk
All images are for illustration only, Please see individual item listings for actual item specifications
Step Stringer Fitting Instructions
SIDE VIEW
Table of contents
Other eDecks Outdoor Furnishing manuals
eDecks
eDecks Parliament Pergola User manual
eDecks
eDecks Step Stringer Handrail User manual
eDecks
eDecks Rosedene User manual
eDecks
eDecks Atlas User manual
eDecks
eDecks Hot Tub Decking Kit User manual
eDecks
eDecks Garden Swing User manual
eDecks
eDecks Modern Deck User manual
eDecks
eDecks Queen Anne User manual
eDecks
eDecks Hot Tub Decking Kit with Roof User manual
Popular Outdoor Furnishing manuals by other brands
forest-style
forest-style HACIENDA 2354 Building instructions
Courtyard Creations
Courtyard Creations RUS0188-WM Assembly instructions
RPR
RPR OLLIE CHAIR manual
kingsley-bate
kingsley-bate MC-55 Assembly instructions
Weltevree
Weltevree Carrier product manual
Grange Fencing
Grange Fencing Elite Arch Assembly instructions
