’
Safety Instructions
For Use By Qualified Personnel Only
When using your machine, basic precautions should always be followed, including the following:
Read all instructions. Use the Mister T2 Pro only for its intended use.
Mister-T2 Pro has to be operated with a precoating liquid for fabrics for DTG printer.
Cleaning MUST be done with distilled water only!
Other liquids alcohol or solvent may damage pumps or other components of the machine.
Damages caused by unauthorized liquids are excluded from the warranty.
Mister-T2 Pro comes with 12 months warranty.
This warranty includes the whole construction of the machine, mechanical parts, electronics, drawer
with rails, casing, pumps, electronic valve, and pipes.
Consumption items such as stainless-steel nozzles, seals, and filters are excluded from the warranty.
The set-up and installation of the machine has to be done under supervision of an authorized person.
The installation has to be done by 2 or more persons following the instructions of this manual.
Caution : The Plug has to be pulled out of the power outlet while maintenance.
La spina deve essere estratta dalla presa di corrente durante la manutenzione.
Never pull cord to disconnect the power, grasp plug and pull to disconnect from power outlet.
Protect the power cord by keeping it away from hot surfaces. Do not allow objects to sit on top of
the cord. This could cause damage to the cord and could become a fire hazard risk.
Caution : Do not operate machine with a damaged cord or if the equipment has been damaged.
Do not
disassemble or
attempt to
repair the machine
to
prevent risks
to
injury.
N'utilisez pas la machine avec un cordon endommagé ou si l'équipement a été endommagé.
Ne démontez pas et n'essayez pas de réparer la machine pour éviter les risques de blessures.
Call or take it to a qualified service person for examination and repair.
Incorrect assembly or repair could increase the risk of fire, electric shock, or injury to persons
when the equipment is used.
Supervision is necessary for any machine being used by or near children. Do not leave equipment
unattended while connected.
Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
To reduce the likelihood of circuit overload, do not operate other high voltage equipment on the
same circuit.
The machine should only be used by trained personal after reading and understanding of the manual.
