Ecoboil EBE Express Series User manual

Water boilers |Water chillers |Boil/Hot units |Boil/Hot/Chill units |Parts & Accessories

EBE Express Series

Automatic Under Bench Water Boilers

Installation and maintenance instructions

Please read prior to installation

Important

This unit must be installed by an authorised plumber

The unit to be connected in accordance with AS 3500.4.1

or AS/NZS 3500.4.2

Do not turn on power to this boiler until water is flowing

from the tap

Please leave these instructions with the owner

WHAT’S IN THE BOX:

1 x EBE Express Boiling Unit

1 x EBE 01 Express Boiling Tap

1 x EB FM 350 kPa PLV

1 x EB 316 Brass fitting kit

1 x Boiling Water Warning Label

Prior to installation

• Minimum Inlet Pressure 260 kPa

• We recommend the fitting of a water filter.

• Only teflon tape to be used where necessary. Under no

circumstances is plumbing paste to be used.

• When fitting this unit in a cupboard of small proportions, please

note that the unit does omit heat. If in doubt fit cross flow vents.

• Do not connect to the hot water line or the fire hydrant supply - to

do so will void the warranty.

Product Information

This unit is fitted with a computerised element and boil dry protection.

The computer is set at 95 Degrees C, altitude will alter the boiling

point.

• The 350 kPa Pressure Limiting Valve supplied must be fitted.

• If fitted with a filter, we recommend changing the cartridge every

12 months.

• The manufacturer recommends cleaning and servicing the unit

every 24 months, or every 12 months in hard water areas.

• If the supplied power cord is damaged, it must be replaced by an

electrician.

• The tap provided is a push through vented tap. After dispenser

water the tap will continue to dispense water until the spout is

empty. This ensure only water is dispensed each and every time.

Installation Instructions

1. Do not plug in the unit or turn on the power until the installation

process is complete.

2. Position the unit underneath the sink as close as possible to its

outlet tap location.

3. Position the tap in the desired location; drill a 40mm hole and

secure the tap firmly.

4. Observing the attached labels:

a. Measure and cut the pipes to the desired length. Do not

lengthen the copper pipes under any circumstances.

b. Connect the 1/4” pipe from the tap to the boiler inlet.

c. Connect the 5/16” pipe from the tap to the boiler outlet.

d. Connect the 1/4” pipe from the tap to the Mains water supply

using the 350 kPa PLV and brass connectors supplied.

e. Push the end of the silicon tube on to the vent pipe of the unit.

5. All pipes and tubes must not be extended and require a

continuous fall between tap and unit.

6. Open tap until water is flowing from the spout.

7. Once water flows out of the tap, plug in the unit to a standard 3

Pin 10 Amp Power Socket and switch on the power. Make sure

the unit is positively earthed.

8. After the power is turned on allow 20 minutes before testing and

using.

9. Check for leaks at all connections.

10. Position ‘Caution Boiling Water’ label close to the tap to alert

users to the water temperature.

Trouble Shooting

SYMPTOM CAUSES ACTION

Water overflowing

from tap spout

Expansion chamber

full

Low inlet pressure

Run tap for 5-10 minutes

Contact water supplier

Excessive steam

from tap

Faulty element Replace element

Water not hot No power supply

Faulty element

Check and test power supply

Replace element

No water Water has been

turned off

Blocked water filter

Check mains water supply

Replace filter cartridge

Water boilers |Water chillers |Boil/Hot units |Boil/Hot/Chill units |Parts & Accessories

For more information about Ecoboil and our products,

visit our website or contact us:

Ecoboil Appliances Limited

Phone 09 238 2209

Fax 09 282 4073

Mail P.O. Box 940, Pukekohe 2340

Web www.ecoboil.co.nz

Table of contents

Other Ecoboil Boiler manuals

Ecoboil

Ecoboil EB Rapid Series User manual

Popular Boiler manuals by other brands

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES operating instructions

Radijator

Radijator BIO max 23.1 instruction manual

Brunner

Brunner BSV 20 Instructions for use

Buderus

Buderus Logamax GB062-24 KDE H V2 Service manual

Potterton

Potterton 50e Installation and Servicing Manual

UTICA BOILERS

UTICA BOILERS TriFire Assembly instructions

Joannes

Joannes LADY Series Installation and maintenance manual

ECR International

ECR International UB90-125 Installation, operation & maintenance manual

Froling

Froling FHG Turbo 3000 operating instructions

Froling

Froling P4 Pellet 8 - 105 installation instructions

U.S. Boiler Company

U.S. Boiler Company K2 operating instructions

Henrad

Henrad C95 FF user guide

NeOvo

NeOvo EcoNox EF 36 user guide

Potterton

Potterton PROMAX SL 12 user guide

Eco Hometec

Eco Hometec EC 25 COMPACT Technical manual

Viessmann

Viessmann VITODENS 200 Operating instructions and user's information manual

Baxi

Baxi Prime 1.24 installation manual

REXNOVA

REXNOVA ISA 20 BITHERMAL Installation, use and maintenance manual