10
Operation/Installation Guide
email - gmsupport@echomaster.com (US) - tel - 866-766-2267
Illustrations are typical and may not match exact vehicle details
email - gmsupport@echomaster.com (US) - tel - 866-766-2267
Accessing Camera and Installation settings
Press and hold the “HOME” button for more than 2 seconds to enter the TC camera view
(input 3).
Camera 4 input is automatically activated when vehicle is in reverse gear when
aftermarket camera option is selected in the Installer Setup.
The camera view is accessible after 7 seconds while in reverse. Press and hold the
“HOME” button for more than 2 seconds to access camera view while in reverse.
Press and hold anywhere on the sceen while in Camera view to access Camera
Setup page shown below. From Camera setup menu you can enable / disable
functions. FIG 1.
1. Enable Front Camera Speedup Trigger - When enabled, will trigger front camera when
entering drive from reverse gear. Turns off above 8 mph.(Only avaliable in full mode)
2.
3. Enable Turn Signal Cameras - When enabled, blind spot cameras will activate and
display on the screen when the turn signals are activated. (Only avaliable in full mode)
4. Enable Dynamic Backup Curves - When enabled, the module will overlay
dynamic backup guide lines over the reverse image aftermarket cameras
only. (Only avaliable in full mode)
Press and hold the small lock icon in the top right corner of the camera
setup menu to access Installer Setup. FIG 2.
1. Enable Aftermarket Backup Camera - can be enabled by pressing this tab.
2. Note: The other options are only avaliable in full mode.
FIG 1 FIG 2
Enable Front Camera Slowdown Trigger - When enabled, it will activate the front
camera when speed is reduced below 10 mph and steering wheel is turned more than
10 degrees. (This prevents unwanted front camera activation in stop and go traffic).
(Only avaliable in full mode)
19367548
Integrated Towing Assistance Package
