Eaton BladeUPS Series User manual
Eaton®BladeUPS®
DoS Installation Instructions
Eaton®BladeUPS®
DoS Installation Instructions
Help Desk Numbers
United States 1-800-356-5737 or 1-800-843-9433
Canada 1-800-461-9166 ext 260
All Other Countries Call your local service representative
Web sites:
l
www.eaton.com/powerquality
NOTE: On the Web site opening page, click Support and select the
Customer Service link for more information.
Eaton, BladeUPS, and X-slot are registered trademarks of Eaton Corporation or
its subsidiaries and affiliates. Phillips is a registered trademark of Phillips Screw
Company. All other trademarks are property of their respective companies.
©Copyright 2019 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No
part of this document may be reproduced in any way without the express written
approval of Eaton Corporation.
Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 i
Table of Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
System Components. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Moving the System and Battery Pallets . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Unloading the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Equipment Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Install the Equipment Modules and Batteries . . . . . . . . . . . . . . . . . . . . . . 11
Wiring and Cabling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
System Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Table of Contents
ii Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3
Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 1
Section 1 Introduction
If any equipment has been damaged during shipment, keep the shipping cartons and packing materials for the
carrier or place of purchase, and file a claim for shipping damage. If you discover damage after acceptance, file
a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with the carrier within 15 days of receipt of
the equipment; 2) Send a copy of the damage claim within 15 days to your service representative.
System Components
The equipment components of the BladeUPS system are shipped as follows:
l1 palletized BladeUPS Cabinet (see Figure 1)
l1 palletized Transformer (not needed if you are using an existing transformer or not using a transformer; see
Figure 1)
Figure 1. BladeUPS Cabinet and Transformer (if ordered)
l2 BladeUPS shipping cartons (see Figure 1 and Figure 2 for more information)
2 Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3
Table 1. Shipped in Each Shipping Carton
Quantity Description
1BladeUPS Module Chassis (delivered with
Electronics Module installed)
1Electronics Module
4Battery Packs
1 package UPS Documentation and Software Tools:
l
IPSS Software Suite CD and Firmware CD
l
Installation instructions and a standard
BladeUPS User’s Guide
2 Door Keys
Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 3
2 Hot Sync CAN Bridge Cards
1CAN Bridge Card Cable
1Redundant Signal Cable
1Input-Output Wire
2Blue Terminating Plugs
1Bypass Switch Contact Cable
Table 1. Shipped in Each Shipping Carton (Continued)
Quantity Description
4 Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3
Figure 2. BladeUPS Shipping Carton
Section 2 Tools
To assemble the components, you may need the following tools:
lForklift or pallet jack
lFlathead (short and long)
lShort- and long-handled medium flat-bladed screwdriver
lShort- and long-handled #2 Phillips® screwdriver
lRatcheting socket wrench and socket for 9/16" screws
l7 mm wrench or socket
lUtility knife
lAdjustable pliers
2Two-screw Brackets
2Ferrite Cores
1 package Assorted jumpers for REPO (see the standard
BladeUPS manual)
May include 2-pin or 3-pin jumpers
Table 1. Shipped in Each Shipping Carton (Continued)
Quantity Description
Table of contents
Other Eaton UPS manuals
Eaton
Eaton 9125 Two-in-One UPS 2500 User manual
Eaton
Eaton 9315 User manual
Eaton
Eaton 3S550IEC User manual
Eaton
Eaton 9910-E16 User manual
Eaton
Eaton Powerware 9170+ UPS 3-18 kVA User manual
Eaton
Eaton Powerware 9390 User manual
Eaton
Eaton 5S 1000VA User manual
Eaton
Eaton 5S User manual
Eaton
Eaton Powerware 5125 User manual
Eaton
Eaton Power Xpert 9395 User manual
Eaton
Eaton 5P 750 User manual
Eaton
Eaton Powerware 9125 User manual
Eaton
Eaton 91PS User manual
Eaton
Eaton Tower 6KS User manual
Eaton
Eaton Powerware 9910-E64 User manual
Eaton
Eaton 93PM IBC-L User manual
Eaton
Eaton 5S 550 User manual
Eaton
Eaton 9390 UPS 100160 kVA User manual
Eaton
Eaton 93PM-L IAC-B User manual
Eaton
Eaton Powerware 9355 User manual
