Eagle P152DA User manual
1 | P a g e
Wired Intercom
P152DA
Instruction Manual
2 | P a g e
INTRODUCTION:
Please read the entire instruction manual before using the product and then save it for future reference.
We reserve the right for any errors in text or images and any necessary changes made to technical data.
If you have any questions concerning technical problems, please contact our Customer Services on
01928 581 284
IMPORTANT SAFETY INFORMATION:
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
Place the appliance on a firm flat surface. Do not place on soft surfaces.
For Indoor Use Only
Do not use in bathrooms, or in wet or damp locations.
Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming
pool.
Do not place the lead beneath a carpet or rug.
Do no insert any object into the appliance through the grilles. This may damage the appliance
or result in overheating or electric shock.
TECHNICAL SPECIFICATION
Model
P152DA
Power Supply
6V DC
3 | P a g e
HOW TO USE
Wiring
Connect the transmission wires as shown in the wiring diagram below. Ensure the wires connect
corresponding terminals.
Battery Installation
1. Open the battery cover on the master station
2. Insert 4x ‘C’ batteries into the battery compartment
3. Close the battery cover
Operation
Call from Master Station
1. Slide the function switch to ON
2. Press CALL/TALK on the master station to make a call
3. Hold CALL/TALK to talk, release to listen
4. Slide the function button to OFF when finished, to put the unit in standby mode
Call from Slave Station
1. Press CALL on the slave station to make a call
2. Talk into the device, you do not need to press any buttons
MAINTENANCE
Before cleaning, turn the appliance off, and disconnect from the power supply. The appliance may
then be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from
the case. Do no use stronger detergents or solvents as these may damage the finish. Using a dry 1"
(25mm) paint-brush, remove any dust from the grilles.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste. Most local authorities have
specific collection system for appliances and disposal is free of charge to the end-user. When
replacing an existing appliance with a similar new appliance your retailer may take the old appliance
for disposal.
4 | P a g e
ENVIRONMENTAL RESPONSIBILITIES:
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local council for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain damaging your health
and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old
appliance for disposal free of charge
SERVICE WARRANTY:
Electrovision Ltd. guarantees the product free from defects in materials and workmanship for a period
of twelve months. Should this appliance be operated under conditions other than those recommended,
at voltages other than the voltage indicated on the appliance, or any attempts made to service or
modify the appliance, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty is in addition to,
and does not affect, your statutory rights. Our guarantee is administered by our retailers. If your
product arrives damaged, you must contact the retailer from whom you bought it. The retailer's contact
details will be on the invoice that arrived with the product, or on the e-mail you received when you
placed the order. Do not contact Electrovision Limited, only your retailer can arrange a replacement.
If your product fails within the guarantee period, firstly read the "fault finding" section of this manual,
because temperature and weather conditions can affect the performance of certain products. If the
product needs to be repaired or replaced, you must contact the retailer from whom you bought it.
The retailer's contact details will be on the invoice that arrived with the product, or on the e-mail you
received when you placed the order. If you have just received your product and require technical help
in using it, please call our Help Desk on 01928 581 284
If you have any other technical queries about the product, please call our Help Desk on 01928 581 284
Electrovision Ltd.
Lancots Lane, Sutton,
St. Helens
Merseyside
WA9 3EX
www.Electrovision.com
Table of contents
