2.2 Steps for Connection:
Following are the steps to properly connect your 4 Ports 11g VoIP ADSL2/2+ Router:
1. Turn off your computer.
2. Connect the ADSL port of your 4 Ports 11g VoIP ADSL2/2+ Router to the wall jack of the
ADSL Line with a RJ-11 cable.
3. Connect the Ethernet cable (RJ-45) from your 4 Ports 11g VoIP ADSL2/2+ Router to the
Ethernet Adaptor in your computer.
4. Plug in your PSTN or PABX line to the FXO jack for out line calls.
5. Plug in your Analog Telephone Set to the FXS (FXS0 or FXS1) port for Internet VoIP
calls (You must have a VoIP account registered before you can make any Internet calls).
6. Connect the Power adaptor to the 4 Ports 11g VoIP ADSL2/2+ Router and plug the
other end into a Power outlet.
Use the Power Adaptor exclusively in combination with th
equipment supplied and do not use any other kind of power adapto
for the equipment.
7. Turn on your 4 Ports 11g VoIP ADSL2/2+ Router.
The Power light will lit after turning on the 4 Ports 11g VoIP ADSL2/2+
Router.
uto and sel
-diagnostic process might turn the LED indicators O
and OFF durin
the
rocess.
8. Turn on your computer.
9. Refer to the next chapter to setup or configure your system’s Network Adaptor.
ll the conf
guration/setting procedures describe in this Quick Star
Guide are run through RJ-45 Ethernet connection. For Wireless
setting, please refer to user manual for details.
4 Ports 11g VoIP ADSL2/2+ Router 5
