Dual MCD139BT Operating instructions
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver
MCD139BT
2
MCD139BT INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove trim ring from unit.
• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring
harness adapter (sold separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
FUSE
When replacing the
fuse, make sure new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio.
The
10 amp AGC fuse
located beside the wiring
connector.
10 AMP
AGC Fuse
unit uses one
Antenna
Connector
Remote Turn On
Connect to amplifier or power
antenna. Insulate wire if not used.
3
MCD139BT INSTALLATION
Wiring Diagram
FUSE
10 AMP
AGC Fuse
When replacing the
fuse, make sure new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio.
The unit uses one
10 amp $7& fuse located
beside the wiring
connector.
Antenna
Connector
Remote Turn On
Connect to amplifier or power
antenna. Insulate wire if not used.
4
MCD139BT OPERATION
Control Locations
Preset 5 / Folder Down
Preset 4 / Play / Pause
Preset 3 / Intro
Preset 2 / Random
Preset 1 / Repeat
Display
Band / Bluetooth Talk
Reset
Tune / Track Up
Tune / Track Down
Release
Speaker Zone 1
Speaker Zone 2 / Mute
Power / Mode
Volume Knob
AS/PS / Go Back
Eject
USB Charging Port
Auxiliary Input
Preset 6 / Folder Up
1 3 4 7
1 11
2 12
3 13
4 14
5 15
6 16
7 17
8 18
9
10
19
9
8
16 15 14 13 12 11 1020 18
26
5
17
19
20
6
MCD139BT OPERATION
Press or any other button (except EJECT) to turn the unit
on. Press to turn the unit off.
Press MODE to select between AM/FM, CD player, Bluetooth,
auxiliary and USB. Modes of operation are shown in the
display.
NOTE: CD and USB modes will not appear unless a CD is
inserted or USB device is connected.
The MCD139BT offers a 3.5 mm auxiliary input port on the
front panel of the unit for connecting an audio device, MP3
player, etc. Press MODE to select auxiliary input mode.
Adjust volume using volume knob (00-4).
Press DISP to show the clock. During playback of MP3/files,
ID3 tag information, elapsed time, track number and file/
folder names will automatically rotate on the display.
Press RESET upon initial installation or if abnormal
operation occurs.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Turn the volume knob to the right to
adjust the hours or to the left to adjust the minutes.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Press and hold AUDIO for more than 3 seconds to access the
setup menu. Press AUDIO momentarily to select between
the menu functions and rotate the volume knob left/right to
adjust or activate the desired function.
Power On/Off
Mode
Auxiliary Input
Volume
Display
Reset
Set the Clock
12/24-hour Clock
Setup Menu
General Operation
7
MCD139BT OPERATION
General Operation - Setup Menu
Menu Function Options Action
Local/Distance
Tuning
LOCAL OFF Activates distance tuning (Tuner mode only).
LOCAL ON Activates local tuning for strong station reception only (Tuner
mode only).
Tuner
Frequency
Spacing
FREQ USA Programs the unit to USA tuner spacing.
(200kHz for FM and 10kHz for AM). (Tuner mode only)
FREQ EURO Programs the unit to European tuner spacing.
(50kHz for FM and 9kHz for AM). (Tuner mode only)
Beep
Confirmation
BEEP OFF Disables the confirmation beep.
BEEP ON Enables the confirmation beep.
Programmable
Turn On Volume PRO-VOL # Programs unit to always turn on at a specific volume (default is
OFF). Any volume level 1-30 can be selected.
Auto Answer
ANSWER
21 Programs unit to automatically answer every incoming phone
call after 2-3 rings.
ANSWER
2)) Programs unit to require the button must be pressed to
answer incoming phone calls (default).
8
MCD139BT OPERATION
Press AUDIO momentarily to select between Bass, Treble,
Balance and Fader.
BASS TREBLE BALANCE /28'EQ
Press AUDIO until BASS appears then rotate volume knob
left/right to adjust ( -minimum / +maximum).
Press AUDIO until TREBLE appears then rotate volume knob
left/right to adjust ( -minimum / +maximum).
Press AUDIO until BAL appears then rotate volume knob
left/right to adjust (BAL L - BAL R).
BAL EVEN represents equal balance
Press Zone 1 to turn the sound from Zone 1 on or off.
Press Zone 2 to turn the sound from Zone 2 on or off.
Audio
Bass
Treble
Balance
Speaker Zone 1
Speaker Zone 2
General Operation
9
MCD139BT OPERATION
AM/FM Tuner Operation
Seek Tuning
Manual Tuning
Band
Storing and Recalling
Station Presets
Automatically Store
Stations
Press TUNE
nn
or TUNE
ll
momentarily to seek to the
next strong station.
Press and hold TUNE
nn
or TUNE
ll
until "MANUAL"
appears, then press TUNE
nn
or TUNE
ll
momentarily
to change radio frequency up or down one step at a time.
Press and hold to advance quickly.
Note: Seek and manual tuning functions are reversed if
Seek Priority is set to SEEK 2 in the setup menu (refer to
page 7 for details on setting Seek Priority).
Press BAND to select between FM1, FM2, FM3, AM1 and
AM2 bands.
Up to 18 FM stations and 12 AM stations can be stored. To
store a station, select the desired band and station. Press
and hold the desired preset button (1-6) for more than
2 seconds. When stored, the preset number will appear in
the display. The Vtation can be recalled anytime by pressing
the corresponding preset button.
Press and hold$636for more than 3 seconds to find auto
store in the display. Then press volume knob to
automatically store strong 6 stations in the current band.
10
MCD139BT OPERATION
Insert CD
Eject CD
Track Select
Fast Forward/Reverse
Pause
Intro
Repeat
Random
CD-R/CD-RW
Compatibility
With the label facing up, insert a standard size CD into the
CD slot. The CD will automatically begin playback.
Press EJECT to eject the CD. The unit will change to
previous mode of operation. If the disc is not removed
within 10 seconds, the unit will reload the disc. The unit
does not have to be turned on to eject CD.
Press TRACK
ll
to skip to the beginning of the next
track. Press TRACK
nn
to return to the beginning of the
current track. Pressing TRACK
nn
again skips to the
beginning of the previous track.
Press and hold TRACK
ll
or TRACK
nn
on the remote
control to fast forward or reverse a track.
Press
l
/
II
to temporarily stop CD playback.
Press
l
/
II
again to resume playback.
3UHVV,17WRDFFHVVWKH,QWURPHQX3UHVV,17WRSOD\WKH
ILUVWVHFRQGVRIHVFKWUDFNSUHVVDJDLQWRFDQFHOWKH,17
IXQFWLRQ
3UHVV537WRDFFHVVWKH5HSHDWPHQX3UHVV537WRWRJJOH
EHWZHHQ5372))537537',5DQG537$//
•5372))&DQFHOVWKH537IXQFWLRQ
•537&RQWLQXRXVO\UHSHDWVVHOHFWHGWUDFN
•537$//3OD\VDOOWUDFNVRQ&'
3UHVV5'0WRDFFHVVWKH5DQGRPPHQX3UHVV5'0WR
WRJJOHEHWZHHQ5'021DQG5'02))
•2))&DQFHOVWKH5'0IXQFWLRQ
•213OD\VDOOWUDFNVLQUDQGRPRUGHU
Some CD-Rs and CD-RWs may be incompatible with this
unit, depending on media type and recording method. In
addition, the following CDs may be incompatible with this
unit:
CDs exposed to extreme temperatures or direct sunlight
for extended periods of time, CDs recorded in which a
recording session failed or a re-recording was attempted
and, or encrypted or copy-protected CDs which do not
conform to the audio CD-DA red book recording standard.
CD Player Operation
11
MCD139BT OPERATION
CD Player Operation - MP3 Files
Playing an MP3 CD
Displaying Information
Title Icon
Artist Icon
Folder Icon
File Icon
Character Support
When an MP3 encoded disc is first inserted,
“DISC READ" will appear in the display. Depending on the
number of files and folders, this may take several seconds.
Press DISP to select between song title, artist, file name,
folder name, track number, and clock/elapsed time.
“NO ARTIST” or "NO TITLE" will be displayed if the MP3 file
contains no ID3 tag information.
“ROOT” will be displayed if the directory name of a root
folder is not labeled.
This icon will illuminate when the song title is displayed.
This icon will illuminate when the artist name is displayed.
This icon will illuminate when the folder name is displayed.
This icon will illuminate when the file name is displayed.
Maximum character display information
• Track name – 32 character maximum
• Directory name – 32 character maximum
• *Song title – 32 character maximum
• *Artist name – 32 character maximum
*Song title and Artist Name will only be displayed if included
with the MP3 file.
When referring to MP3 playback, the following terms
are synonymous:
• File name and track name
• Folder name and directory name
Table of contents
Other Dual Car Receiver manuals
Dual
Dual XDVD1175BT Operating instructions
Dual
Dual XDVD8183 Operating instructions
Dual
Dual XDVD8285 Operating instructions
Dual
Dual DC208BT User manual
Dual
Dual MXD103 Operating instructions
Dual
Dual DXDM228BT Operating instructions
Dual
Dual DV1014BH Operating instructions
Dual
Dual DV516BT Operating instructions
Dual
Dual XML8100 Operating instructions
Dual
Dual XDVD3101 Operating instructions
Dual
Dual DMCPA70 Operating instructions
Dual
Dual XDM270 Operating instructions
Dual
Dual AXXERA XDMA7800 Operating instructions
Dual
Dual XDVD1262 User manual
Dual
Dual SD XDMA6370 Operating instructions
Dual
Dual DVM179 Operating instructions
Dual
Dual DC525Bi Operating instructions
Dual
Dual XDM6830 Operating instructions
Dual
Dual XDM7615 Operating instructions
Dual
Dual XDMR6850 Operating instructions
