DRAX TBU9000 User manual
Be sure to read the manual before using the product in order to use safely and
correctly. Please keep user manual at a place to be available easily.
USER’S MANUAL
Exercise Bike Series
TBR9000
TBU9000
V1.2E
EU
1. GETTING STARTED
2. INSTALLATION
3. HOW TO USE
- HOW TO ADJUST THE SADDLE
- DISPLAY AND CONSOLE OPERATION PANEL
- CONTROL PANEL
- BASIC START-UP
- HOW TO USE THE PROGRAM MODE
4. THE WORKOUTS
- WORKOUT DESCRIPTIONS
- PRESET MODE
- HEARTRATE CONTROL MODE
5. SPECIFICATION
6. MAINTENANCE
7. LIMITED WARRANTY
2
3
6
6
7
8
9
10
14
14
15
16
17
18
20
CONTENTS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1 GETTING STARTED
SAFETY INSTRUCTIONS _
Please read and fully understand this user manual prior to using this machine. Please keep this manual
in a safe and handy place for future reference.
Failure to adhere to the following could potentially void your warranty.
Always disconnect power supply when servicing/cleaning or during extended periods of non-
operation of this exercise equipment.
Do not attempt to disassemble this exercise equipment.
Only authorized service providers may service this equipment.
Do not operate this exercise equipment if damaged or if any abnormal noises are heard.
Please Contact DRAX INC. Customer Support Center for assistance.
•
The owner of exercise equipment must inform all users of the safety instructions and correct
operating procedure for this exercise equipment.
• Always operate the exercise equipment in accordance with the supplied instructions.
• Always ensure that this exercise equipment is installed on flat level ground prior to operation.
•
Always ensure that this exercise equipment installed in a low humidity and low dust environment.
•
Do not operate this exercise equipment prior to proper installation.
(Please refer to installation instructions)
• Always ensure that children and pets are kept off this exercise equipment.
• The maximum user weight supported by the exercise equipment is 150kg.(330lbs)
• Never allow more than one person on this exercise equipment at any one time.
• Always wear appropriate clothing and footwear when using this exercise equipment.
Do not wear baggy loose clothes.
•
Always ensure that the machines power cord is neatly wrapped up and protected from being
walked on, pinched or damaged in anyway.
A damaged power cord has the potential to cause an electrical shock or fire.
• Do not remove the plug by pulling on the cord and do not handle the plug with wet hands.
This could result in electric shock, fire or damage to the cord and equipment.
• Do not allow uncontained food or drink on or near this exercise equipment.
• Regularly inspect this exercise equipment to ensure safe operation.
Warning
Caution
2
BECYCLE
3
① Display
④ Console Column
⑦ Foot
⑩ Saddle Lever
② book hanger Supported
⑤ Console
⑧ Pedal
⑪ Operation Panel
③ Touch type Heartrate
⑥ Cup Holder
⑨ Saddle
2 INSTALLATION
PRECAUTIONS _
(1) Always ensure that this exercise equipment is installed on flat level ground and feet are leveled
and locked into place prior to operation.
(2) Always only use the grounding type power cord that is supplied with the exercise equipment.
UpRight Bike
PART NAME _
4
① Display
④ Console Column
⑦ Foot
⑩ Saddle Lever
② book hanger Supported
⑤ Console
⑧ Pedal
⑪ Operation Panel
③ Touch type Heartrate
⑥ Cup Holder
⑨ Saddle
Recumbent Bike
BECYCLE
HOW TO ASSEMBLE/INSTALL _
(1) Make sure whether “components as shown below” are delivered or not.
(2) If some of components are not delivered, Contact DRAX INC. Customer Support Center.
(3)
To make a installation, deliver components into a flat place. For delivery, 1 or 2 Persons lift the Exercise
Bike-rear side. You can conveniently deliver it by pushing Exercise Bike due to front roller.
※ Caution: The Exercise Bike must be installed in the environment where it is low humidity and
low dust area.
(4) Make a connection of Cables among “Bike Body ASSY” and “Console and Handle ASSY”.
CHECK OPERATION _
(1) After plugging , check that the screen power is ON.
(2) Press the pedal on the bike to see if it rotates normally .
(3)
If it rotates normally, press all the switches on the control panel to check whether it operates normally.
(4) If abnormal vibration or noise occurs on the product, please contact the DRAX Service Center.
5
6
3 HOW TO USE
HOW TO ADJUST THE SADDLE _
(1) UPRIGHT BIKE
To check the proper position, if you need to adjust the seat, mount on the bikes seat.
Pull up the seat adjustment lever as shown in figure.
Adjust the seat post up or down into the desired position.
(2) RECUMBENT BIKE
To adjust the seat, pull up the seat adjustment lever and slide the seat guide to the desired position.
Release the lever and slide the seat guide back and forth slightly until it locks into position.
(3)HOW TO ADJUST THE PEDAL STRAPS
To adjust the pedal straps, first pull the end of the straps off the tabs on the pedals.
Adjust the straps to the desired positions, and the press the straps back onto the tabs.
① Saddle ② Saddle Lever ③ Pedal ④ Pedal Strap
For effective exercise, the saddle should be in the proper position or height, As you pedal.
there should be a slight bend in your knees when the pepals are in the lowest position.
Up Right Bike Pedal strap Recumbent Bike
BECYCLE
7
DISPLAY AND CONSOLE OPERATION PANEL _
① Pace/Distance Change
④ Program
⑦ TIME
⑩ Undo Initialization
② RPM/Speed Change
⑤ Pause
⑧ LEVEL
③ Dotmatrix 16 x 8
⑥ TIME Control
⑨ LEVEL Control
8
CONTROL PANEL _
① START/STOP Button
When you start exercise or finish exercise, push this button.
② Level Adjust Button
This button is used to adjust the intensity of exercise.
[∧ : High intensity, ∨ : Low intensity]
① START/STOP Button ② Level Adjust Button
Control Panel Control Panel
BECYCLE
9
BASIC START-UP _
Quick Start
1. Turn on the console.
when you begin to pedal, the console will automatically be turned on and
“select workout or QUICK START will appear on the display.
2. Press the QUICK START key.
3. Begin exercising and adjust the resistance level.
As you exercise, adjust the resistance of the exercise bike as desire
by pressing the UP(+) and DOWN(-) or numeric keys.
4. Measure your heart rate if desired.
To use the handgrip heart rate sensor, Place your hands on the metal contacts.
Your palms must be on the upper contacts and your fingers must be thuching the lower contacts,
Avoid moving your hands. When your heart rate is detected, H/R ♥ will blink for a moment and then
your heart rate will be shown.
5. To end your workout, stop pedalling on the bike.
You can also press the PAUSE/STOP key. In either case, the displays on the console freeze, allowing
you to review your workout statistics.
If the pedals are not moved, the console will automatically be tumed off to conserve the battery.
To dismount, step off the highest pedal first.
PAUSING WORKOUTS
To pause a workout, press the PAUSE key, which brigns the resistance level
down near zero.
To continue a paused workout, press the PAUSE key again or the ENTER key.
Note that the user must continue pedaling during a pause in order to retain the
current workout information.
If the user stops pedaling, the workout automatically ends, and the information is lost.
This manual suits for next models
1
Table of contents
