Draper 20582 User manual

Original Instructions

Version 1

20582

12V

CORDLESS

AIR COMPRESSOR

1. Preface

– 2 –

These are the original product instructions. This

document is part of the product; retain it for the life

of the product, passing it on to subsequent holders.

Read this manual in full before attempting to

assemble, operate, or maintain this product.

This Draper Tools manual describes the purpose

of the product and contains all the necessary

information to ensure its correct and safe use.

Following all the instructions and guidance in

this manual will ensure the safety of both the

product and the operator and increase the

lifespan of the product.

All photographs and drawings within this manual are

supplied by Draper Tools to help illustrate correct

operation of the product.

Every eort has been made to ensure the

information contained in this manual is accurate.

However, Draper Tools reserves the right to amend

this document without prior warning. Always use the

latest version of the product manual.

1.1 Product Reference

User Manual for: 12V Cordless Air Compressor

Stock No: 20582

Part No: DA12/151

1.2 Revisions

Version 1: March 2018

First release

Version 1.1: April 2022

General revision and image updates

As our manuals are continually updated, always ensure

that the latest version is used.

Download the latest version from:

drapertools.com/manuals

1.3 Understanding the Safety Content

WARNING! – Situations or actions that may result in

personal injury or death.

CAUTION! – Situations or actions that may result in

damage to the product or surroundings.

Important: – Information or instructions of particular

importance.

Permission is granted to reproduce this manual for

personal and educational use ONLY. Commercial

copying, redistribution, hiring, or lending is strictly

prohibited.

No part of this manual may be stored in a retrieval system

or transmitted in any other form or means without written

permission from Draper Tools Limited.

In all cases, this copyright notice must remain intact.

2. Contents

– 3 –

1. Preface 2

1.1 Product Reference 2

1.2 Revisions 2

1.3 Understanding the Safety Content 2

2. Contents 3

3. Warranty 4

4. Product Introduction 5

4.1 Scope 5

4.2 Specication 5

5. Health and Safety Information 6

5.1 General Safety Instructions for Compressors 6

5.2 General Safety Information for Battery Packs

and Chargers 6

5.3 Connection to the Power Supply 7

6. Identication and Unpacking 8

6.1 Product Overview 8

6.2 What’s in The Box? 9

6.3 Packaging 9

7. Preparing the Air Compressor 10

7.1 Charging the Battery (230V) 10

7.2 Using the 12V DC In-Car Adaptor 10

7.3 Notes on Battery Life 11

8. Operating Instructions 12

8.1 Using the Compressor 12

8.2 Using the Ination Adaptors 13

8.3 Using the Light 13

9. Maintenance and Troubleshooting 14

9.1 General Maintenance 14

9.2 Troubleshooting 14

10. Disposal 15

11. Explanation of Symbols 16

3. Warranty

– 4 –

Draper Tools products are carefully tested and inspected

before shipment and are guaranteed to be free from

defective materials and workmanship.

Should the tool develop a fault, return the complete tool

to your nearest distributor or contact Draper Tools

directly. Contact information can be found at the back of

this manual.

Proof of purchase must be provided.

If, upon inspection, it is found that the fault occurring is

due to defective materials or workmanship, repairs will

be carried out free of charge. This warranty period covers

parts and labour for 24 months from the date of

purchase. Where tools have been hired out, the warranty

period covers 90 days from the date of purchase.

This warranty does not apply to any consumable parts,

batteries or normal wear and tear, nor does it cover any

damage caused by misuse, careless or unsafe handling,

alterations, accidents, or repairs attempted or made by

any personnel other than the authorised Draper Tools

repair agent.

In all cases, to make a claim for faulty workmanship or

materials within the standard warranty period, please

contact or return the product to the place of purchase.

Proof of purchase may be required.

If the place of purchase is no longer trading or if you

experience any diculties with your warranty, please

contact Customer Services with the product details and

your proof of purchase. Contact details can be found at

the back of this manual.

If the tool is not covered by the terms of this warranty,

repairs and carriage charges will be quoted and charged

accordingly.

This warranty supersedes any other guarantees

expressed or implied and variations of its terms are not

authorised.

Your Draper Tools guarantee is not eective until you can

produce, upon request, a dated receipt or invoice to

verify your purchase within the guarantee period.

Please note that this warranty is an additional benet

and does not aect your statutory rights.

Draper Tools Limited

4. Product Introduction

– 5 –

4.2 Specication

Stock No. 20582

Part No. DA12/151

Rated voltage 12V

Battery type Li-ion, 1,500mAh

Charging time 3h

Maximum current 10A

Maximum pressure 150psi (10.3bar)

Recommended cycle time 15min

Display unit psi/bar/KPa

Power cable length 3.5m

Hose length 150mm approx.

Weight (excluding accessories) 800g

Battery charging adaptor

Rated input 230V~50Hz

Rated voltage 12V

Rated current 1.5A

4.1 Scope

This multi-functional air compressor is designed to

inate tyres, dinghies and sports equipment as part of

domestic and infrequent trade use. The product also

includes an LED lamp for visibility and to attract

attention. Any other application beyond the conditions

established for use will be considered misuse.

Draper Tools accepts no responsibility for improper use

of this product.

WARNING! This product is not a toy and must be

respected.

Read this manual in full before attempting to assemble,

operate or maintain the product, and retain it for later use.

5. Health and Safety Information

– 6 –

Important: Read all Health and Safety instructions

before attempting to operate, maintain or repair this

product. Non-compliance with these instructions may

result in injury or damage to the user, the product or the

item to be inated.

5.1 General Safety Instructions for

Compressors

• WARNING! This compressor is capable of supplying

air at high pressure. NEVER point this product at

any person or any object for which its use is not

intended.

• Observe and adhere to all standard safety precautions

and good practices when working in a workshop

environment.

• Keep the work environment clear and well-lit,

with bystanders at a safe distance.

• Before use, inspect the product carefully for signs of

damage or battery leakage.

WARNING! DO NOT use this product if damage or

defects are present; take it out of service until it has

been repaired or replaced. Contact Draper Tools for

repair and replacement options. If the power

adaptor or charger cords are damaged, they must

be replaced by a special cord available from Draper

Tools or its authorised service agents.

• ALWAYS ensure that the air hose and valve

connections are tight and secure, and rmly hold the

item to be inated during operation.

• ALWAYS ensure that the trigger lock is in the “locked”

position before inserting the battery or power

adaptor.

• DO NOT use this product in wet conditions or expose

it to rain.

• DO NOT use this product near ammable or

combustible materials or in dangerous or explosive

environments.

• DO NOT store the product with the battery pack still

attached.

• DO NOT attempt to open or modify this product in

any way.

• NEVER leave the compressor running unattended and

allow it to stop completely before moving away.

• Use this product ONLY for the recommended cycle

time and allow approx. 30 minutes for it to cool before

the next use, subject to environmental conditions.

WARNING! Extended continual use of the product

may cause it to overheat and harm both the product

and the operator.

• After use, ALWAYS check the tyre pressure using a

tyre pressure gauge that complies with

BS EN 12645:2014.

• CAUTION! NEVER exceed the maximum pressure

recommended by the manufacturer of the item to

be inated. Check the manufacturer information

before every use and continually monitor the item

during ination.

• NEVER carry the compressor by the hose.

• ONLY use accessories supplied by Draper Tools.

5.2 General Safety Information for

Battery Packs and Chargers

Important: This product is supplied with a 1,500mAh

battery pack. Use ONLY the battery pack and charger

supplied with this product.

• WARNING! NEVER charge non-rechargeable

batteries.

• WARNING! DO NOT use the battery if there is

evidence of leakage. If battery uid comes into

contact with your skin, rinse the aected area

immediately with water. If it comes into contact

with your eyes, ush with plenty of water and seek

medical advice.

• NEVER attempt to open the battery for any reason.

• Charge the battery in a dry and well-ventilated

environment in ambient temperatures between 5

and 40°C.

• Use ONLY the charger supplied with the product to

charge the battery pack.

• DO NOT short-circuit the battery by connecting the

positive and negative terminals while it is detached

from the product.

− Keep the battery away from metallic objects that

may inadvertently cause connection of the

terminals.

• DO NOT store the battery pack in environments with

ambient temperatures exceeding 50°C.

• Dispose of the battery pack responsibly and in

accordance with local regulations.

5. Health and Safety Information

– 7 –

5.3 Connection to the Power Supply

Always ensure that the power supply on the machine’s

rating plate is compatible with the power supply to which

you intend to connect it.

The rechargeable battery pack is supplied with a UK

standard three-pin plug and is intended for connection

to a domestic power supply rated at 230V AC. An in-car

power adaptor is also supplied and is intended for

connection to a 12V DC socket found in vehicle interiors.

This is a Class II†appliance and is designed for

connection to a power supply matching that detailed on

the rating label and compatible with the plug tted.

CAUTION! Use ONLY the power supplies provided.

Important: If using an extension lead, follow the

instructions that came with your lead regarding

maximum load while the cable is wound. If in doubt,

ensure that the entire cable is unwound. Using a coiled

extension lead will generate heat which could melt the

lead and cause a re.

†Double insulated : This product requires no earth

connection as supplementary insulation is applied to the

basic insulation to protect against electric shock in the

event of failure of the basic insulation.

6. Identication and Unpacking

6.1 Product Overview

– 8 –

(1) LCD pressure display

(2) Compressor power button

(3) Increase pressure button

(4) Decrease pressure button

(5) Trigger

(6) Trigger lock

(7) Attachment lock

(8) SMD LED light on/o switch

(9) SMD LED light

(10) Battery release button

(11) 12V Battery pack

(7)

(8)

(5)

(6)

(9)

(10)

(11)

(1)

(2)

(3) (4)

6. Identication and Unpacking

– 9 –

6.2 What’s in The Box?

Carefully remove the product from the packaging and

examine it for any signs of damage that may have

occurred during shipment.

Before assembling the product, lay the contents out and

check them against the parts shown below. If any part is

damaged or missing, do not attempt to use the product.

Please contact the Draper Helpline; contact details can

be found at the back of this manual.

6.3 Packaging

Keep the product packaging for the duration of the

warranty period for reference should the product need to

be returned for repair.

WARNING! Keep packaging materials out of reach of

children. Dispose of packaging correctly and

responsibly and in accordance with local regulations.

Please visit drapertools.com for our full range of accessories and consumables.

(A) 1 x 12V air compressor

(B) 1 x Air hose

(B1) Air hose attachment

(B2) Threaded hose connector

(D) 1 x Inating adaptor

(E) 1 x 12V battery pack

(F) 1 x 12V DC in-car power adaptor

(G) 1 x 230V adaptor

(H) 1 x Storage bag

(H)

(E) (F)

(G)

(B)

(B2)

(B1)

(D)

(C)

(A)

– 10 –

Important: Charge the compressor for ve hours before

rst use.

7.1 Charging the Battery (230V)

1. If installed, remove the battery from the base of the

compressor by pressing the battery release button

(10) and pulling the battery (11) downwards.

2. Insert the 230V adaptor (G) pin into the battery pack

and connect the plug to a 230V mains power socket.

3. The charging status is indicated by the LED on the

charging adaptor:

− Red LED: The battery is charging.

− Green LED: The battery is fully charged.

4. Disconnect the 230V adaptor and insert the battery

back into the compressor, ensuring it locks into place.

Charging may take up to three hours. The compressor

should run for approximately 15 minutes on a full charge.

Important: To preserve the battery health, Draper Tools

recommends that the compressor charging time does

not exceed ve hours.

7.2 Using the 12V DC In-Car Adaptor

Important: The 12V adaptor is not a battery and can

only be used with an active power supply. Unravel the

cord fully before use. Always ensure that the cable runs

through the hole at the base of the adaptor.

1. If installed, remove the battery from the base of the

compressor by pressing the battery release button

(10) and pulling the battery (11) downwards

(Fig. 1–2).

2. Insert the 12V DC in-car adaptor (F) into the base of

the compressor, ensuring it locks into place.

3 Fig.

2 Fig.

4 Fig.

1 Fig.

7. Preparing the Air Compressor

(10)

(11)

(G)

Other manuals for 20582

Table of contents

Popular Air Compressor manuals by other brands

Sparmax

Sparmax DC-25XR user manual

KAESER

KAESER M122 Service manual

GMC

GMC GAC1500 Original instructions

Briggs & Stratton

Briggs & Stratton Air Compressor Operator's manual

Fini

Fini F3GST2TK Operator's manual

Industrial Air

Industrial Air CP1580325 Operator's & parts manual

Campbell Hausfeld

Campbell Hausfeld RP3300 Easy setup guide

Ingersoll-Rand

Ingersoll-Rand UP6 20 HP Option manual

Hitachi

Hitachi EC99S Instruction manual and safety instructions

Parkside

Parkside PKO 270 A1 operating instructions

Sullair

Sullair 185 manual

Clas Ohlson

Clas Ohlson QIE-ZTH-15 manual

Ferm

Ferm CRM1046 Original instructions

BE AC153 Operation manual

RIDGID

RIDGID OF25150A Operator's manual

Johnson Controls

Johnson Controls QUANTUM LX Setup

Sears

Sears Craftsman 919.167463 owner's manual

Ring Automotive

Ring Automotive RAC700 instructions