Dji Phantom 2 Vision + User manual

Other manuals for Phantom 2 Vision +

17

Popular Quadcopter manuals by other brands

Autel Robotics

Autel Robotics EVO II Dual 640T quick guide

Carson

Carson X4 NANO instruction manual

Attop

Attop W80 Instructions for use

Alias

Alias 6608 owner's manual

Reely

Reely Drone Copter 2-in-1 operating instructions

Hubsan

Hubsan FPV X4 H107D instruction manual

Falcon

Falcon S2-210 quick start guide

Kaiser Baas

Kaiser Baas KBA15007 user guide

Denver Electronics

Denver Electronics DCH-261 instructions

Craig

Craig INTERCEPTOR owner's manual

Odyssey

Odyssey TURBO RUNNER manual

IMAGINARIUM

IMAGINARIUM droni stream instructions

Hubsan

Hubsan X4 Pro FPV instruction manual

AR.Drone

AR.Drone Parrot VSM user guide

Walkera

Walkera QR X900 quick start guide

HobbyZone

HobbyZone Zugo instruction manual

Ares

Ares RECON FPV owner's manual

Skycat

Skycat XS user manual

Place the Phantom on its head

(make sure battery is removed)

Remove jack plug out of the camera

Pull the frame careful out of the rubber holders

(Careful: there is a wire connected to the camera)

Manual DJI Phantom 2 Vision Dronexpert Gimbal

All manuals and user guides at all-guides.com

all-guides.com

Disconnect the camera connector

Remove the frame for the Phantom body

You will have now removed camera and frame:

All manuals and user guides at all-guides.com

Remove white rubber cover and loosen (remove) the screw

Remove the vision camera from the frame

Remove the plastic inlay

All manuals and user guides at all-guides.com

Place screw back screw with the inlay in the frame so you do not lose it.

Place the outside rubber cover back on the Vision camera.

Overview photo

All manuals and user guides at all-guides.com

Now take the gimbal and included parts out of the case

Put rubber tubes in the camera (where screws are located). Press the

tubes all the way down to the end.

Place the camera (jack) connector as show on the images

All manuals and user guides at all-guides.com

Place the screws in the rubber tubes as shown on the image

All manuals and user guides at all-guides.com

all-guides.com

All manuals and user guides at all-guides.com

Now put the jack connector into the vision camera.

IMPORTANT: Make sure the sensor plate is mounted horizontal

All manuals and user guides at all-guides.com

Paste the cable extender on the belly of the Phantom as shown on the

image and connect it. Make sure you keep enough space for you Phantom

battery.

Move your compass to a lower position

All manuals and user guides at all-guides.com

Paste dampers in the corners of the landing gear as shown below

Now place the gimbal mount between the landing gear, first one side then

the other side. The landing gear of the Phantom is quite flexible. The right

landing gear and pull it with fixed-close strength aside and place the

mount on its place as shown on the image below

All manuals and user guides at all-guides.com