Dimplex PLX075NN User manual

Convector Heater

PLX075NN/PLX100NN/PLX150NN/PLX200NN

1. Important Information

Please read carefully all the information provided in

these instructions. Keep the instructions in a safe place

and if necessary give them to any future owner.

-The device may only be installed by an authorized

and qualified technician.

-The unit may only be used for space heating in

enclosed rooms.

-Any examination of the heater or repair work may

only be carried out by a qualified electrician.

-Disconnect the heater from the power supply if it is

faulty or is not used for a long time. Disconnect or

shut off the power at the breaker.

-Do not cover the heater in any way (risk of fire).

- Warning: Outer surfaces become hot when heater

is switched on.

-The heater must not be operated by children or

other persons not capable of using the appliance in

a safe manner. Children must be prevented from

playing with the appliance.

-Do not insert any objects into the openings.

-Do not use the heater in rooms containing

flammable materials (e.g. solvents, etc.).

-Do not place the connecting lead on top of the

appliance.

WARNING:

If the heater is switched on automatically, there is a

danger of fire if it has been in any way covered or

blocked.

2. Positioning, Installation, Minimum Clearances

When installed, the heater must be aligned horizontally

on a vertical wall, as shown in the illustration.

The minimum clearances shown must be complied

with.

In addition, a minimum distance of at least 20” must be

maintained in front of the heater.

The heater must not be located directly beneath a wall

socket outlet.

Do not install the heater where the controls can be

reached by a person bathing or showering.

CAUTION:

Do not place near flammable objects.

Ensurethataircanenterandleavetheheaterfreely,at

the inlets below and the outlets above.

The recess box must be accessible for inspection after

theappliancehasbeenmounted.

Wall Mounting

IMPORTANT

Theoriginalwallbracketssuppliedattachedtotherear

of the unit must be used.

-Drill mounting holes for the wall brackets.

-Screw the brackets securely to the wall.

-Hang the heater from the wall brackets using the slits

in its rear wall.

-Secure the heater at the top on the wall brackets.

3. Electrical Connection

All wiring must comply with National Electrical codes

and local codes and utility requirements. This

installation should be entrusted to duly qualified

personnel where required by law.

Connect the supply wire into a properly rated recess

box. Consult your local electrical code for applicable

wire gauge. Connect L1 from the power supply to the

blue wire from the unit, connect the L2 wire from the

power supply to the brown wire from the unit, and

connectthegroundtotheyellow/greenwirefromthe

unit.

5 15/16”

16 15/16”

1-888-346-7539

7207930100r01

4. Anti-Overheat

Theheaterisprotectedwithasafetydevicetoprevent

overheating. Shouldthe heateroverheat due toimpeded

air circulation the automatic cutout will turn the heater off.

Theheater will reactivate once the heaterhascooled.

Keep the air inlets and outlets free of dust to ensure that

maximum heat output is available. Before the start of the

heatingseason, vacuum-clean theheater to remove any

dirt or dust.

5. Possible Faults

If the heater does not give out any warmth, check that

the thermostat is set to the correct temperature. Then

check the fuse or circuit breaker.

If the cause of the fault cannot be identified, contact the

nearestafter-salesservice center.

You must state the unit model number, as indicated on

the type plate (wiring compartment cover). Any

examination of the heater or repair work may only be

carried out by a qualified electrician or after-sales

service technician.

6. Cleaning

Before cleaning, ensure that the heater is disconnected

from the power supply and that it has cooled down. The

outer surface can be wiped with a soft damp cloth. Do

not use scouring powder or furniture polish, as these

can damage the surface.

Dust that collects within the unit can be removed from

the outside using a vacuum cleaner.

7. Technical Data

Power supply voltage 240/208volts

Protection class I Protective earth terminal

Protectionsystem IP 24

Drilling dimensions (front view)

8. Warranty

Two year limited warranty on complete unit, plus an

additional 10 year warranty on the elements. The

warranty is not valid without a sales receipt marked with

the date of purchase.

A5 15/16”

5 15/16”

16 15/16”

5 1/2”

7 1/4”

4 1/8”

2 1/2”

10”

4 5/8”

5 15/16”

8 7/16”

Cable entry

1367 Industrial Road

Cambridge, Ontario

Canada, N1R 7G8

1-888-DIMPLEX

1-888-346-7539

Type Voltage Output Weight Width Height Depth Dim A

PLX075NN 240/208 750/562W 6.2 kg 24 5/16” 16 15/16” 4 1/2” 11 1/4”

PLX100NN 240/208 1000/750 W 6.2 kg 24 5/16” 16 15/16” 4 1/2” 11 1/4”

PLX150NN 240/208 1500/1125W 6.6 kg 27” 16 15/16” 4 1/2” 13 15/16”

PLX200NN 240/208 2000/1500W 8.0 kg 33 3/4” 16 15/16” 4 1/2” 20 11/16”

This manual suits for next models

Other Dimplex Heater manuals

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide