READ CAREFULLYREAD CAREFULLY
When the batteries have not enough power to close the lock the led red turn ON and stays ON until the complete
discharge of the batteries. ( approximately 3 days )
Replace them only with ALKALINE batteries ( AAA ) observing the right polarities.
Do not use rechargable batteries
BATTERIES ( see page 5 )
OBSTACLE ( see page 7 )
PASSEPARTOUT CODE
CLEANING
Clean the lock exclusively with a dump cloth.
Avoid soap, solvents, alcohol etc.
AVOID TO MAKE ENTER THE WATER IN THE LOCK
If the water gets inside the lock in addition to discharge the batteries can permanently damage the lock
If the discharged batteries remain in the lock they could release some acid substances which damage the contacts
When you noted that the led is ON replace as soon as possible the batteries.
To avoid confusion is advisable to program the same code for all the locks installed.
In this case remove the obstacle or verify that the door is well-aligned and adjust, if it necessary, the hinges of the door
or the stop-bolt
FEW INSTRUCTIONS AND SOME SUGGESTIONS TO KEEP EFFICIENT THE LOCKSFEW INSTRUCTIONS AND SOME SUGGESTIONS TO KEEP EFFICIENT THE LOCKS
If during the closing ( or the opening ) the red led flashes quickly 8 times this means that the bolt has met an
obstacle and it unable to close ( or open ).
When you have the need to change the passepartout code verify that the new passepartout programmed
works correctly after the changing
11
2299
4433
5577
PAGE 4
ATTENTION
PLEASE NOTE THAT THE NON-OBSERVANCE OF THE RULES IN THIS GUIDE FOR A CORRECT
MAINTENANCE WILL AUTOMATICALLY VOID EVERY KIND OF WARRANTY OF THE PRODUCT.
