Denver REC-34 User manual

Other manuals for REC-34

2

Table of contents

Popular Clock Radio manuals by other brands

Audiovox

Audiovox CE90 Operation instructions

Sony

Sony Dream Machine ICF-C763L operating instructions

Sanyo

Sanyo DMP-P6 instruction manual

RCA

RCA RPC100 user manual

Yamaha

Yamaha ISX-80 owner's manual

Pyle

Pyle PLMR20W user manual

Blaupunkt

Blaupunkt CR7BK user manual

Philips

Philips AJ3180 Specifications

HoMedics

HoMedics SS-5500-2EU instruction manual

RCA

RCA RC66i user manual

Versaudio

Versaudio Vers user manual

SOUNDMASTER

SOUNDMASTER UR8100 instruction manual

Audiovox

Audiovox CE90 operating instructions

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio instruction manual

Roberts

Roberts ChronoDAB user manual

AEG

AEG MRC 4132 BT instruction manual

Tokai

Tokai TC-155 user manual

Timex

Timex T300 manual

ENG - 1

DENVER REC-34 - QUICK START GUIDE

www.facebook.com/denverelectronics

Start-up (radio controlled clock)

1. Open the battery compartment and pull the batteries in it.

2. When inserting the batteries, the clock will scan the DCF frequency signal ( ) flashes on the LCD

if the signal is OK).

3. The clock manually scans the time signal by pressing wave for 2 seconds. For failed reception in 5

minutes, scanning stops.

4. () turns on indicate signal received successfully.

Manual time setting

1. When the LCD display the TIME, hold “TIME” button for 2 seconds to enter clock/Calendar

setting.

2. Press “UP” or “DOWN” buttons to adjust the setting and press “TIME” button to confirm each

setting.

3. The setting sequence is shown as follow: 12/24H display, Hour, Minute, Year, Month, Date and

Language.

Adjust the Daily Alarm

1. Hold the “ALARM” button for 2 seconds to enter ALARM time setting. Press “UP” or “DOWN”

button to adjust the ALARM time.

2. Press “ALARM” button to switch ALARM on or off. If it is on.

Time Zone

By standard unit is set to GMT+1. To change this push TIME button for 2 seconds, then choose first

24h, push time once, then change Time zone (standard is 00=GMT+1) to the Time zone at your place

and confirm by pushing time again. Then either set the time manually, or wait until unit returns to

normal mode and push WAVE button to start scanning after RCC time.

Other usage

Press “DOWN” button to select temperature in Celsius mode or Fahrenheit mode.

ENG - 2

ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S

Electric and electronic equipment contains materials, components and substances that can be

hazardous to your health and the environment, if the waste material (discarded electric and electronic

equipment) is not handled correctly.

Electric and electronic equipment is marked with the crossed out trash can symbol, seen below. This

symbol signifies that electric and electronic equipment should not be disposed of with other household

waste, but should be disposed of separately.

All cities have established collection points, where electric and electronic equipment can either be

submitted free of charge at recycling stations and other collection sites, or be collected from the

households. Additional information is available at the technical department of your city.

Imported by:

DENVER ELECTRONICS A/S

Stavneagervej 22

DK-8250 Egaa

Denmark

www.facebook.com/denverelectronics