DELTA DORE TYXIA 1705 User manual
TYXIA 1705
EN
1514
1/ Location/Mounting 14
1.1 Mounted on the wall 14
1.2 Placed on a at surface 15
2/ Wireless association 16
2.1 Associating a motor or receiver 16
3/ Save the favourite positions 19
4/ Use 20
5/ Troubleshooting 21
ContentsTechnical characteristics
• Power supplied by 3V lithium battery, CR2430
• Class III insulation
• X3D Transmission frequency:
868.7 MHz to 869.2 MHz
• Maximum radio power < 10 mW
• Receiver category II
• Wireless range: 100 to 300 metres outside,
variable depending on the associated equipment
(the range can vary depending on the installation
conditions and the electromagnetic environment)
• Mounted on a base
• Dimensions: 46 x 121 x 10.7 mm
• Degree of protection: IP 40
• Operating temperature: 0 to +55°C
• Storage temperature: -10 to +70°C
• Installation in an environment with normal
pollution levels
EN
1716
1.2 Placed on a flat surface
1/ Location/Mounting
1.1 Mounted on the wall
EN
1918
> 3s
2/ Wireless association
This chapter allows you to associate a remote
control with an X3D wireless motor or X3D roller
shutter receiver.
2.1 Associating a motor or receiver
2.1.1 A single motor is turned on
❶Set the motor or receiver to association standby
mode.
❷On the remote control press and at the
same time and hold for 3 seconds, until the LED
ashes. Release.
❸ The shutter is activated briey to conrm the
association.
To exit association mode, press for 3 seconds.
❶ Activating association standby mode
- Motor:
1) Upon turning on for the rst time, if the motor
was not associated before.
2) From a remote control used for the motor
(already associated) press the button for 3
seconds.
- Receiver: press its button for 3 seconds until the
LED ashes.
EN
2120
2/ Wireless association
2.1.2 Several motors or receivers are in association
standby mode
❶On the remote control press and at the
same time and hold for 3 seconds, until the red
LED ashes. Release.
The remote control searches the different motors or
receivers.
Its LED ashes, alternating red/green.
❷ When the LED starts ashing red slowly, press
the button as many times as required to select
the motor (receiver) to associate.
The corresponding shutter activates briey.
❸Once the motor (receiver) has been found, press
.
❹ The shutter is activated briey to conrm the
association.
To exit association mode, press for 3 seconds.
2.2 Associate multiple motors or receivers
❶Set the motors (receivers) to association standby
mode.
❷On the remote control press and at the
same time and hold for 3 seconds, until the LED
ashes. Release.
The remote control searches the different motors or
receivers. Its LED ashes, alternating red/green.
❸ When the LED starts ashing red slowly, press
and at the same time and hold for 3
seconds until the red LED turns on.
❹ The shutters are activated briey to conrm the
association.
To exit association mode, press for 3 seconds.
EN
2322
> 3s
3/ Save the favourite positions
You can save up to 2 favourite positions: and
.
❶❷ Set the shutter to the required position e.g.
).
❸Press or to set the angle of the slats.
❹Press + or + and hold for 3
seconds to save the position.
The shutter is activated briey.
Release.
4/ Use
• Press , or to control the roller shutter.
The green LED indicates that the receiver has
correctly received the information.
• Press or to set the angle of the slats.
• Press to go to favourite
position 1 (if it has been saved).
• Press to go to favourite
position 2 (if it has been saved).
EN
2524
CR 2430
5/ Troubleshooting
• The red LED ashes
several times every time
a button is pressed.
The battery is low.
Change the battery.
• Remove an association
- Remove the front face of
the remote control.
- Press button A.
The red LED ashes.
- Press as many times as
required to select the motor
(receiver) to remove.
- Press the button.
- Press button A to exit.
• Remove all associations
- Remove the front face of the remote control.
- Press button A.
The red LED ashes.
- Press the and buttons at the same time and
hold for 3 seconds.
- Press button A to exit.
www.deltadore.com
Table of contents
Other DELTA DORE Remote Control manuals
DELTA DORE
DELTA DORE DRIVER 610 User manual
DELTA DORE
DELTA DORE TL 2000 Tyxal+ User manual
DELTA DORE
DELTA DORE TYXIA 1701 User manual
DELTA DORE
DELTA DORE TL 2000 TYXAL+ User manual
DELTA DORE
DELTA DORE TYXIA 1703 User manual
DELTA DORE
DELTA DORE TYXIA 1600 User manual
DELTA DORE
DELTA DORE PACK TYXIA 541 User manual
DELTA DORE
DELTA DORE TL 2000 TYXAL+ User manual
DELTA DORE
DELTA DORE TL 2000 TYXAL+ User manual
DELTA DORE
DELTA DORE TYPHONE 3 SV User manual
