Dell PowerEdge 4220 User manual

Dell™ PowerEdge™ 4220

Installation Guide

Guide d'installation

Installationsanleitung

設置ガイド

Guía de instalación

Dell™ PowerEdge™ 4220

Installation Guide

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use of

your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if

instructions are not followed.

WARNING: A WARNING indicates a potential for property damage, personal

injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden

Dell, the DELL logo, and PowerEdge are trademarks of Dell Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

October 2008 P/N N159M Rev. A00

Contents 3

Contents

Safety Instructions. . . . . . . . . . . . . . . . . . . . . 5

SAFETY: Rack Mounting of Systems . . . . . . . . . 5

Rack Installation Instructions . . . . . . . . . . . . . . . 5

Rack Requirements . . . . . . . . . . . . . . . . . . 6

Before You Begin . . . . . . . . . . . . . . . . . . . 6

Installation Tasks . . . . . . . . . . . . . . . . . . . 7

Recommended Tools and Supplies. . . . . . . . . . 7

Removing and Replacing the Rack Doors . . . . . . 8

Removing and Replacing the Side Panels . . . . . 12

Reversing the Front Door (optional) . . . . . . . . 15

Securing the Rack Leveling Feet . . . . . . . . . . 22

Installing the Rack Stabilizer Feet . . . . . . . . . 24

Adjusting the Rack Posts (optional) . . . . . . . . 26

Routing Cables . . . . . . . . . . . . . . . . . . . 27

Coupling Two Racks . . . . . . . . . . . . . . . . . . . 32

Index . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35

4Contents

Installation Guide 5

Safety Instructions

Use the following safety guidelines to ensure your own personal safety and to

help protect your system and working environment from potential damage.

For complete safety and regulatory information, see the safety instructions

that shipped with your system. Warranty information might be included in

this document or as a separate document.

SAFETY: Rack Mounting of Systems

Observe the following precautions for rack stability and safety. Also refer to

the rack installation documentation accompanying the system and the rack

for specific caution statements and procedures.

Systems are considered to be components in a rack. "Component" refers to

any system as well as to various peripherals or supporting hardware.

CAUTION: Instructions for Rack-Mounted Systems:

• Your rack kit has been approved only for the rack cabinet provided. It is

your responsibility to ensure that installation of the equipment into any

other rack complies with all applicable standards. Dell disclaims all liability

and warranties with respect to combinations of equipment with any other

rack.

• Before installing your equipment in a rack, install all front and side

stabilizers. Failure to install stabilizers can allow the rack to tip over.

• Always load from the bottom up, and load the heaviest items first.

• Do not overload the AC power supply branch circuit that provides power

to the rack.

• Do not stand or step on any components in the rack.

Rack Installation Instructions

This installation guide provides instructions for trained service technicians

installing a 42-unit (U) rack. Information includes assembling the rack,

coupling two 42-U racks, and routing cables through the rack. The 42-U rack

can be installed using the recommended tools.

Before attempting this installation, you should read through this entire

procedure carefully.

6Installation Guide

Rack Requirements

CAUTION: The 42-U rack meets the specifications of American National

Standards Institute (ANSI)/Electronic Industries Association (EIA) standard

ANSI/EIA-310-D-92, Consumer Electronics Association (CEA) Standard CEA-310-E,

International Electrotechnical Commission (IEC) 297, and Deutsche Industrie Norm

(DIN) 41494.

Before You Begin

WARNING: Before you begin installing your rack, carefully read "Important

Safety Information", as well as the safety instructions that came with the rack.

WARNING: When installing multiple systems in a rack, complete all of the

procedures for the current system before attempting to install the next system.

WARNING: Rack cabinets can be extremely heavy and move easily on the

casters. The cabinet has no brakes. Use extreme caution while moving the rack

cabinet. Retract the leveling feet when relocating the rack cabinet. Avoid long or

steep inclines, rough surfaces, or ramps where loss of cabinet control may occur.

Extend the leveling feet for support and to prevent the cabinet from rolling.

WARNING: Avoid rolling the rack cabinet over rough surfaces. Hard impacts to

the casters could cause them to break, and the rack could become unstable and

tip over.

WARNING: Do not attempt to move your rack with components installed.If you

move a fully loaded rack on a slightly uneven floor surface, the rack may become

unstable and tip over.

Important Safety Information

Observe the safety precautions in the following subsections when installing

your system in the rack.

WARNING: You must strictly follow the procedures in this document to protect

yourself as well as others who may be involved. Your system may be very large

and heavy, and proper preparation and planning are important to prevent injury

to yourself and to others. This becomes increasingly important when systems are

installed high up in the rack.

WARNING: For stability, you must ensure that a minimum of 50 lbs. is installed in

the bottom 3-U spaces of the rack cabinet.

Installation Guide 7

Rack Stabilizer Feet

WARNING: Installing systems in a rack without the front and side stabilizer feet

installed could cause the rack to tip over, potentially resulting in bodily injury

under certain circumstances. Therefore, always install the stabilizer feet before

installing components in the rack.

WARNING: After installing systems in a rack, never pull more than one system

out of the rack on its slide assemblies at one time. The weight of more than one

extended system could cause the rack to tip over and cause injury.

The stabilizer feet help prevent the rack from tipping over when a system or

other component is pulled out of the rack with the slide assemblies fully

extended.

Installation Tasks

Installing a rack cabinet involves performing the following tasks:

Removing and replacing the rack doors

Removing and replacing the side panels

Reversing the front door and badge (optional)

Securing the leveling feet

Installing the stabilizer feet

Adjusting the rack posts (optional)

Routing cables through the rack

Coupling two racks (optional)

Recommended Tools and Supplies

You may need the following tools and supplies to install the rack:

• #2 Phillips screwdriver

• Flat head screwdriver

• 12-mm wrench

• Needle-nose pliers

• 4-mm Allen wrench (if you want to reverse the direction that the front

door opens)

• Keys to the rack doors and side panels

• 13-mm wrench (for rack removal from pallet)

• 17-mm wrench (for rack removal from pallet)

8Installation Guide

Removing and Replacing the Rack Doors

WARNING: Because of the size and weight of the rack cabinet doors, never

attempt to remove or install them by yourself.

WARNING: When storing the doors, lay the doors flat so they cannot fall over and

accidentally injure someone.

Removing the Front Door

Pull the door latch and open the front door all the way (see Figure 1-1).

While holding the door, pull the hinge pin upward so that it clears

the door’s hinge-pin housing (see Figure 1-1).

The hinge pin’s retention clip prevents the hinge from being pulled out of

the hinge body.

Figure 1-1. Removing the Front Door

1 door latch 2 hinge pin

3 hinge body 4 hinge-pin housing

Other manuals for PowerEdge 4220

Table of contents

Languages:

Other Dell Rack & Stand manuals

Dell

Dell EMC A16 Rails User manual

Dell

Dell OptiPlex 780 User instructions

Dell

Dell PowerVault 770N User manual

Dell

Dell SPR-WL2-MNT User manual

Dell

Dell POWER VAULT 130T LIBRARY 130T User manual

Dell

Dell PowerConnect W-AP134 User manual

Dell

Dell B13 User manual

Dell

Dell PowerVault MD1120 User manual

Dell

Dell SFF User manual

Dell

Dell A20 User manual

Dell

Dell Mid-Mount Operating and maintenance manual

Dell

Dell PowerVault 770N User manual

Dell

Dell Precision 7920 User manual

Dell

Dell SPR-RK3-MNT User manual

Dell

Dell 9020 SFF User manual

Dell

Dell VersaRails Instruction Manual

Dell

Dell PowerVault 130T User manual

Dell

Dell OptiPlex 780-USFF User manual

Dell

Dell OptiPlex 780-USFF User manual

Dell

Dell PowerVault MD3060e Series User manual

Dell

Dell OptiPlex SFF 980 User manual

Dell

Dell PowerEdge 2420 Quick start guide

Dell

Dell PowerEdge 21DXJ User manual

Dell

Dell OptiPlex 780-USFF User manual

Popular Rack & Stand manuals by other brands

Salamander

Salamander Acadia AC/W/L400/WH Assembly instructions

Fohhn

Fohhn VAT-09 Mounting instruction

ricoo

ricoo FS0522 quick start guide

AMSOIL

AMSOIL BMK-22 Installation and service instructions

Kargo Master

Kargo Master 48220 installation guide

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 installation instructions

ricoo

ricoo S1222 installation instructions

Ready-Set-Mount

Ready-Set-Mount RSMCM602 instruction manual

VidaBox

VidaBox VB MNT FFS2 installation guide

Welch Allyn

Welch Allyn 48960 Assembly instructions

Arkon

Arkon CM035-ST-2 installation instructions

PROEL

PROEL PLWIN60C user manual

Agilent Technologies

Agilent Technologies E2609B installation guide

Mustang

Mustang MV-ARM4 installation guide

Mounting Solutions

Mounting Solutions WRM-320 manual

Pyle

Pyle PMKSPAD1 manual

ShelterIt

ShelterIt 21208 installation instructions

SPL

SPL RackPack?4 1040 manual 