SERIES 2300-CA
SLIDING DOOR OPERATORS
Page No. 6
SPECIFICATIONS
Series 2300CA Rack & Pinion Drive Corridor Device
A. Entry and Vestibule Door Operation Device – Door weight not to exceed 400 lbs
1. Housing unit entry and vestibule doors for Level III and Administrative Segregation Housing Units shall have fully
automatic sliding doors with functions and components as follows:
a. Unlock, open and lock open by electric switch, a 36 inch wide door in not more than eight seconds.
b. Unlock, close and deadlock closed, by electric switch, a 36 inch door in not more that eight seconds.
c. Stop the movement of any door in mid-travel, leaving the door fixed at that point, so that it cannot be
moved by hand in either direction until mechanically released with the paracentric key at the door lock
pilaster or reactivated electrically.
d. Instantly reverse the direction of movement of any individual door.
e. When a door is blocked and blocking object is removed, the door automatically continues movement to the
open or closed position if switch is still depressed.
f. Sally port or vestibule doors shall be interlocked so that only one door can be opened at a time using
electric controls. Interlocking circuit shall be provided at Control Console under provisions of Division 17.
g. Force exerted by the door in travel shall be 40 to 45 lbs., adjustable Solid State Motor Controller.
h. Each door automatically deadlocks closed at two concealed points at the rear of the door; at bottom and
top of lockbar. The locking means is completely concealed and there are no openings in the pilaster or
lugs projecting from the edge of the door.
i. Individual doors may be unlocked mechanically and may be operated electrically from both sides of the
door by the same paracentric key..
g. Each door has a limit switch at each end of travel, an additional switch monitors the position of the lockbar.
The switches indicate three conditions – closed and locked, open and locked, and in-travel.
k. The Door Operator is capable of adjustment within the transom.
2. Components
a. Motor is 1/10 horsepower, single phase, 120V, 60 Hertz, U.L. listed manufactured by Reliance Electric.
Motor draws no more than 1.5A under full load current.
b. Hanger Guides: 3/16 inch thick steel plate; minimum width 75 percent of door width.
c. Hanger to interlock with track support with a clearance of not more than ¼ inch.
d. Hanger Support Roller: Turned from solid steel, 2-3/4 inch O.D. grooved 3/8 inch deep to engage 5/8”
diameter steel track.
e. Rollers shall have anti-friction ball bearings with hardened members and grease shield on both sides.
f. Roller Studs and Eccentric Adjusters: High alloy steel, heat treated and a self-locking nut.
g. Provide heavy duty rubber bumpers, minimum 2 inch round x ¾ in deep, to quiet and cushion the door at
each end of travel.
h. Paint entire inside of housing assembly, except track, rollers and drive mechanism with rust inhibiting
primer.
