Danfoss IP21/Type 1 Conversion Kit User manual

The instructions provide information about installing the IP21/

Type 1 conversion kit in VLT

AutomationDrive FC 360,

enclosure sizes J6 and J7.

Only Danfoss authorized, qualied personnel is allowed to

repair this equipment. The personnel must be familiar with the

instructions and safety measures described in the

VLT

AutomationDrive FC 360 Service Guide.

Items Supplied

•

IP21 top cover

•

NEMA conduit box

•

NEMA base cover

•

Screws and washers, M4x7 (8 pieces)

Description Ordering number

IP21/Type 1 Conversion Kit, J6 132B0376

IP21/Type 1 Conversion Kit, J7 132B0377

Table 1.1 Ordering Numbers

Tools Required

•

T20 screwdriver

Safety Instructions

WARNING

DISCHARGE TIME

The frequency converter contains DC-link capacitors, which

can remain charged even when the frequency converter is

not powered. High voltage can be present even when the

warning LED indicator lights are o. Failure to wait the

specied time after power has been removed before

performing service or repair work can result in death or

serious injury.

•

Stop the motor.

•

Disconnect AC mains and remote DC-link supplies,

including battery back-ups, UPS, and DC-link

connections to other frequency converters.

•

Disconnect or lock PM motor.

•

Wait for the capacitors to discharge fully. The

minimum waiting time is specied in Ta b le 1 . 2 .

•

Before performing any service or repair work, use

an appropriate voltage measuring device to make

sure that the capacitors are fully discharged.

Voltage [V] Power range [kW

(hp)]

Minimum waiting time

(minutes)

380–480 30–75 (45–100) 15

Table 1.2 Discharge Time

Installation Instructions

IP21/Type 1 Conversion Kit

Enclosure Sizes J6 & J7

VLT®AutomationDrive FC 360

Installation

1. Mount the top cover on the top of the frequency

converter.

2. Fasten with 4 screws, 2 screws on each side.

3. Tighten the screws to 1.5 Nm (13.3 in-lb).

1Topcover

Illustration 1.1 Mounting the Top Cover

4. Mount the conduit box on the bottom of the

frequency converter.

5. Fasten with 2 screws, 1 screw on each side.

6. Tighten the screws to 1.5 Nm (13.3 in-lb).

1Conduitbox

Illustration 1.2 Mounting the Conduit Box

7. Mount the conduit cover on the bottom of the

frequency converter.

8. Fasten with 2 screws, 1 screw on each side.

9. Tighten the screws to 1.5 Nm (13.3 in-lb).

1Conduitcover

Illustration 1.3 Mounting the Conduit Cover

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on

order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss