Dakota Alert PR-1000 User manual
CODE MATCHING & TONE SELECTION
Entering learning mode
Press and hold the ‘Learning’
button for 3 seconds. The LED
#1 will ash indicating that zone
1 is ready to be programmed.
To program zones 2-4, press the
‘Learning’ button again to cycle
through each zone. Press the
‘Melody’ button to select one of
18 melodies/tones. Activate the
transmitter to learn the new code.
After selecting the zone and melody, activate the transmitter once. If the
coding is successful, the chime will generate a short tone.
If another LED lights up, this remote button is already programmed on
the zone that lights up.
The Siren sound is intended for use as a panic button and will sound for
one minute.
Delete the transmitter on the chime memory
Enter the learning mode by pressing and holding the ‘Learning’ button
for 3 seconds. Press the ‘Learning’ button to select the zone you want to
delete. Press and hold both the ‘Leaning’ button and the ‘Melody’ but-
tons 3 seconds. The chime will generate a tone to indicate the remote on
this zone has been deleted.
Change the melody/tone on desired zone
Enter the learning mode by pressing and holding the ‘Learning’ button
for 3 seconds. Press the ‘Learning’ button to select the zone you want to
change. Press the ‘Melody’ button to select the new melody/tone and
then activate the transmitter for the selected zone. You will hear a tone
to indicate the melody has been changed.
Reset button
Pressing the ‘Reset’ button will stop the chime and light after the unit has
been activated.
PR1000 PORTABLE RECEIVER INSTRUCTIONS
Contact Dakota Alert:
32556 E Main St.
Elk Point, SD 57025
ph: 605.356.2772
www.DakotaAlert.com
PARTS & FUNCTION
WARNING: This device complies with Part 15 of the FCC rules, Operation of this device is subject to the following conditions: 1.This device may not cause
harmful interference. 2.This device must accept any interference, including interference that may cause undesired operation.
MOUNTING
Hang on wall or clip on belt.
POWER
1. Slide to open the battery
cover.
2. Insert 2 AA batteries.
3. Close the battery cover.
Learning
button
Melody
selector
PORTABLE RECEIVER.indd 1 10/17/2013 9:01:53 AM
All manuals and user guides at all-guides.com
all-guides.com
PORTABLE RECEIVER.indd 2 10/17/2013 9:01:53 AM
All manuals and user guides at all-guides.com
Other Dakota Alert Security Sensor manuals
