
PLANNING
GUIDE
www.Dacor.com Phone: (800) 793-0093
All specications subject to change without notice.
Install all appliances according to accompanying installation instructions. CI.12
Stiffener
Cabinet face
Countertop
Floor
3/8” Min. (10 mm) space
behind raised vent
chassis to clear stiffener
3/8” Min. (10 mm)
flat countertop overhang
required behind cutout
ERV or PRV series raised
vent: Check raised vent
dimensions/specifications
to determine proper fit
SGM Series Cooktop
RGC/SGM Series Drop-In Gas Cooktop
with ERV/PRV Series Raised Vent
COMBINATION INSTALLATIONS
Document # PGCI-008 Revised 05/07/09 Page 1/2
WARNING
Observe all governing codes and ordinances during• planning and installation. Contact your local building
department for further information.
All appliances must be installed in accordance with the• accompanying installation instructions.
All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted
Cutout Dimensions
Side View - RGC/SGM Series Cooktop with
ERV/PRV Series Raised Vent
IMPORTANT: Be careful to use the correct cutout diagram (on page 2/2) to determine the countertop dimensions. Carefully double check
all dimensions against the table below and the correct diagram before cutting the countertop.
* Total cutout depth, accommodates both the cooktop and raised vent
** IMPORTANT: Notch depth is included in total cutout depth (D). DO NOT add notch depth to total cutout depth (D).
RGC or SGM series cooktop
Countertop Dimensions
Installation Type Cutout
Diagram C (minimum) D E F G H
RGC/SGM304 with
ERV30 or PRV30 Figure 1
(Square) 3/8”
(10 mm) 22 1/2” *
(572 mm) 27 3/4”
(686 mm) NA NA NA
RGC/SGM365 with
ERV36 or PRV36 Figure 1
(Square) 3/8”
(10 mm) 22 1/2” *
(572 mm) 33 5/8”
(854 mm) NA NA NA
RGC/SGM466 with
PRV46 Figure 2
(Notched) 3/8”
(10 mm) 22 1/2” *
(572 mm) 44 3/4”
(1137 mm) 43 1/2”
(1105 mm) 5/8”
(16 mm) 2 5/8” **
(67 mm)