DAC DA-110RS User manual
For product information, visit:
www.dacsolution.com
Copyright 2014 Digital Accessories Corporation
DA-110RS
digital dictate station
Setup
1. Using the telephone line cord supplied, plug one end into the unit’s
Data jack (located on the bottom), and the other end into the system or
phone jack.
2. Connect the power adapter to the A/C jack on the unit’s le t side.
3. Plug the handset cable into the unit’s Handset jack (located on the
bottom), and the other end into the handset.
Auto-Log
One-touch dialer #10 (bottom right) is used or the Auto-Log eature. I
the Auto-Log switch is on, whatever is programmed to this dialer will
automatically be dialed. This could be a phone number or perhaps user
ID.
The Auto-Log switch is located on the back o the unit.
DIP Switches
There are our DIP switches located on the bottom o the unit. Switches
1 & 2 determine which emulation the unit uses.
DIP Switch 1: On=Dictaphone emulation (DIP switch 2 must be o ).
DIP Switch 2: On=Lanier emulation (DIP switch 1 must be o ).
DIP Switch 3: Not used.
DIP Switch 4: On=Programming enabled. O =Programming disabled.
Programming Dia ers
Be ore proceeding, veri y that you have ollowed Setup steps 1-3, that
DIP switch 4 is on, and that the Auto-Log switch is off.
1. Pick up the handset and then connect to your system (this may
require entering a user ID and even dialing a telephone number).
2. Press Store.
3. Dial the number(s) you wish to have stored.
4. Press the one-touch dialer you desire to program.
Repeat steps 2-4 or additional dialers.
Emu ation
There are 2 di erent emulations or this model. The emulation
determines what digits are sent with the handset unctions. You may
change the emulation at any time with the DIP switches.
Name Record Incrementa REW/P ay Stop
Dictaphone 2 3 1
Lanier 2 3 4
Other DAC Cordless Telephone manuals
