Page5
Introduction
TheMaxRp110remoteNMEA0183datarepeaterwillsimultaneously
display five sets of data on three digital displays and two bar graphs.
The MaxRp110 can display up to eight separate NMEA 0183 data
sentences arriving on four different NMEA 0183 inputs. You can
view NMEA data such as depth, wind speed/direction, GPS bearing
anddistanceto waypoint, exhaustgastemperature, battery volts,etc.
The MaxRp110 recognizes over 5,800 different NMEA sentences
which can be displayed in a variety of different formats. High and
Low alarms can be set for each set of data. Display damping can be
programmed for four of the eight input channels to average the
readingsandslow thespeedatwhichthedisplayedvalue canchange.
Separate scaling and end limits can be set for the two bar charts so
you can zoom into the data range of interest. For example you can
set a bar chart limit from 0.00 to 24.00 to view NMEA battery volts
or you could zoom into the range of 11.25 to 12.50 if you wish.
You can quickly switch between sixteen different sets of display
configurations for each of the three digital displays and the two bar
charts using the front panel keys. Display configurations 1 - 6 have
been factory pre-programmed to display some popular NMEA data
but can easily be reprogrammed to show different NMEA data.
Thefrontpanel keysare alsousedto selectfrom five backlightlevels
(including OFF). Backlights can also be externally switched ON/
OFF. A built-in editor enables you to set/change alarm levels and
change display damping. Changes are automatically saved to a
nonvolatile memory.
Thereare19differenticonssuchas“DEPTH”,“RPM”,and“SPEED”
