CRUSSIS CROSS Series User manual
Seřízený představec řádně dotáhněte.
Dotahovací moment 4 Nm
Installation instructions for kick scooters - series CROSS
Step 1. Step 2. Step 3.
Step 4. Step 5. Step 6.
Step 7. Step 8. Step 9.
Step 10. Step 11. Step 12.
Make sure that cartoon is not damaged Remove the kick scooter out of the box Remove the tape holding front and
rear wheel
Remove the protecting material from frame Remove the protecting material
from handlebars
Put wheels aside
Loosen the screws on the stem
and align so that it faces forward while riding
In this step set the direction
of the stem roughly.
You will align it precisely later with the wheel on
Tighten the screws on the stem with force 4 NM
Remove the screws from the front part
of the stem
Attach the handlebars Put back the front part of the stem
and lightly tighten, adjust the angle
of the handlebar and screw it with 4 NM
www.kickscooters-crussis.eu
Nasaďte přední kolo do vidlice
Nasaďte rameno brzdy na brzdovou čelist
Step 13. Step 14. Step 15.
Step 16. Step 17. Step 18.
www.kickscooters-crussis.eu
Remove the plastic stopper from between
the brake pads. ATTENTION! DO NOT PRESS
BRAKE LEVER UNTIL YOU PUT
THE WHEEL BACK ON!
Put from wheel back on,
tighten quick release.
Mind the direction of the wheel
Correct position of the quick release axle
to the fork after tightening
Stem and front wheel must form a single axis.
Make sure that stem is properly tightened
with force 4 NM
Check the slope of the handlebars
so it will suit the angle of the brake levers.
We recommend setting at 45 degrees
We wish you many happy kilometers
on your new
kick scooter CRUSSIS!
Other CRUSSIS Scooter manuals
