INSTALLATION INSTRUCTIONS
CM-CWC-1
Cree SmartCast™ Technology Wireless Control Module Replacement Kit
Includes: CR Series and CS Series
LPN00243X0001A0_C
1 of 2
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Before installing turn off the power at the circuit breaker.
2. Any changes or modications to these devices not explicitly approved by
manufacturer could void your authority to operate this equipment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
1
2Cree Logo
Cree Logo
STEP 1:
Turn power off and remove old control module
from luminaire by pressing the clips located on
both sides of control module inward and pull
control module out from luminaire.
NOTE: For location of the control module
reference Figure 1 for CR luminaires and
Figure 2 for CS luminaires.
STEP 2:
Orient the new control module so that the
Cree logo is in the lower left corner. Attach the
new control module to the CR or CS luminaire
by pressing in on the clips located on the sides
of the control module and inserting it into the
designated connector.
STEP 3:
Turn power on. The new control module is
correctly installed if the Blue LED displays a 2
blink sequence.
NOTE: If the blue LED does not respond
with the two-blink sequence, please follow
the RESET instructions to return the control
module to factory defaults.
STEP 4:
On the Configuration Tool, select “Replace
Devices” from the “Advanced” menu and
follow the on-screen directions.. This will
remove old device(s) from the network and
add the new device(s).
RESET
NOTE: The Blue LED is located behind the
Cree logo on the control module. The Cree
logo with illuminate blue when the Blue LED is
active.
STEP 1:
Actuate RESET button through the test hole.
Push and hold (approximately 10 sec), LED on
control module will blink fast.
STEP 2:
Release for 1 sec.
STEP 3:
Press/Hold RESET button for 0.5 sec. Light
will go to full bright and the Blue LED on
the control module should be in a 2 blink
sequence.
TO INSTALL:
