Cradlepoint MBR1200 User manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate this equipment.

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be

installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Following three 3.5G card have passed co-located EMC/RF exposure test with this device and could be used with this device.

Other 3.5G card may or may not comply with the FCC rule, please consult manufacture before purchase.

The EUT could be applied with one 3.5G 1XEV-DO Card and following four different models could be chosen; therefore emission

tests are added for simultaneously transmit between wireless LAN and 3.5G 1XEV-DO function. The emission tests have been

performed at the worst channel of both WLAN and 3.5G 1XEV-DO, and recorded in the report.

Interface Brand name Model name FCC ID

Cardbus KYOCERA KPC650 OVFKWC-KPC650

USB port SIERRA WIRELESS AirCard 875U N7N-MC8775U

USB port SIERRA WIRELESS AirCard 595U N7N-MC8725U

Express card Sprint AirCard 597E N7NAC597E

Industry Canada Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two

conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause undesired operation of the device

This device has been designed to operate with an antenna having a maximum gain of 4.98dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna

impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP

is not more than required for successful communication.

IMPORTANT NOTE:

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance 20cm between the radiator & your body.

MOUNTING PROCEDURE

There are three ways for mounting the CEP:

Wall mounting

1. Locate a high position on the wall that is free of obstructions.

2. Connect two screws in the wall 5cm (2 in.) apart. Do not screw the screws all the way into the wall.

Important!

Make sure that the screws are securely fixed to the wall and strong enough to hold the weight of the CPE.

Other manuals for MBR1200

Table of contents

Other Cradlepoint Network Router manuals

Cradlepoint

Cradlepoint E100 User manual

Cradlepoint

Cradlepoint COR IBR350 User manual

Cradlepoint

Cradlepoint COR IBR600 User manual

Cradlepoint

Cradlepoint MBR1200B User manual

Cradlepoint

Cradlepoint AER 2100 User manual

Cradlepoint

Cradlepoint CBR400 User manual

Cradlepoint

Cradlepoint AER1600 Series User manual

Cradlepoint

Cradlepoint CRADLEPOINT IBR60 User manual

Cradlepoint

Cradlepoint MBR1400 Series User manual

Cradlepoint

Cradlepoint AER1600 Series User manual

Cradlepoint

Cradlepoint MBR1400 Series User manual

Cradlepoint

Cradlepoint AER 2100 System manual

Cradlepoint

Cradlepoint WIPIPE MBR1000 User manual

Cradlepoint

Cradlepoint CRADLEPOINT IBR650 User manual

Cradlepoint

Cradlepoint wipipe CTR350 User manual

Cradlepoint

Cradlepoint MBR1400 Series User manual

Cradlepoint

Cradlepoint wipipe CTR350 User manual

Cradlepoint

Cradlepoint R1900 Series User manual

Cradlepoint

Cradlepoint WIPIPE MBR1000 User manual

Cradlepoint

Cradlepoint AER1600 Series User manual

Cradlepoint

Cradlepoint ARC CBA850 User manual

Cradlepoint

Cradlepoint MBR1400 Series User manual

Cradlepoint

Cradlepoint E102-C7C User manual

Cradlepoint

Cradlepoint AER3100 Series User manual

Popular Network Router manuals by other brands

Allnet

Allnet ALL0333AU user guide

HomeSeer

HomeSeer HT-SEL Getting started guide

Sercomm

Sercomm Genesis OC3505D Quick installation guide

Billion

Billion BIPAC 5102 Series user manual

TP-Link

TP-Link TD-8817 QIG

Motorola

Motorola MR1900 user guide

Digi

Digi IX14 user guide

Cisco

Cisco NCS 540 Hardware installation guide

XAVi

XAVi X8821e user manual

BEC

BEC 6200WZL Quick installation guide

MikroTik

MikroTik hAP ac3 Series quick start

Korenix

Korenix JetNet 5428G Series user manual

NETGEAR

NETGEAR FS526T - Switch installation guide

Korenix

Korenix JetNet 5710G Series user manual

Automated Logic

Automated Logic ZN551 Technical instructions

Cisco

Cisco ASR 1000 Series Installation and configuration guide

EnGenius

EnGenius ESR-9710 quick start guide

Cisco

Cisco 805 Series Product overview