Cornelius FCB Cord Kit User manual

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

INSTALLATION INSTRUCTIONS

FCB CORD KIT FOR V-SERIES 4 FLAVOR

The following instructions should be used for installation of a power cord for a V-Series 4 Flavor unit.

Each kit will supply power to 1 unit.

Parts List

Tools Required

Phillips Screwdriver

Flat Screwdriver

Pliers

CAUTION – Only trained and certified electrical technicians should service this unit. ALL WIRING

MUST CONFORM TO NATIONAL AND LOCAL CODES.

DANGER – To avoid possible serious injury or death the ELCB (earth leakage circuit breaker) must

be installed in the electrical circuit of all units.

WARNING – To avoid possible electrical shock make sure the unit is properly grounded by con-

necting the earth ground cable, in the power cord to any connection in the machine marked with a

ground symbol.

CAUTION – The wiring must be properly grounded and connected through a disconnect switch

(slow-blow fuse or equivalent HVAC/R circuit breaker).

Electrical Requirements

Refer to the nameplate to determine the power requirements before connecting electrical power to the

unit. Voltage across contactor terminals L1 and L2, with the compressor running, must be within voltage

limits described in Table 1.

If the line voltage does not meet these requirements see the possible corrective actions in Table 2.

Item

Number Description Qty

150 Amp Power Cord 1

2Strain Relief 2

Table 1

Unit Requirements

V-Series 4 Flavor Integral Condense 208-230V, 60Hz, 50 Amp

V-Series 4 Flavor Water Condense 208-230V, 60Hz, 50 Amp

Table 2

Voltage Corrective Action

Below 180 VAC Do Not Connect Unit

180-190 VAC Boost voltage by +32 V

191-207 VAC Boost voltage by +16 V

208-230 VAC Use line voltage

231-246 VAC Reduce voltage by –16 V

247-262 VAC Reduce voltage by –32 V

Above 262 VAC Do Not Connect Unit

Revision Date: March 24, 2014 www.cornelius.com Revision: B

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

Installation Steps

1. Switch the power to the unit off or remove the fuse to the electrical power circuit breaker.

2. Remove the back panel and the right side panel to gain access to the electrical area in the back of

the unit.

3. Remove the cover of the contactor box.

4. On both strain relief parts, loosen the screws until no threads show through the bottom.

5. Install the first strain relief to the bottom of the unit.

6. Install the second strain relief to the side of the con-

tactor box.

7. Feed the power cord through the first strain relief,

lead end first, from the outside of the unit to the

inside of the unit.

8. Pull the power cord to the second strain relief.

FCB Cord Kit for V-Series 4 Flavor Installation Instructions

9. Feed the power cord through the second strain

relief from the side into the contactor box.

10. Attach the two outside leads from the power cord to

the right side of the compressor contactor.

11. Remove the top ground nut from the ground stud.

Slip the ring of the middle ground lead over the

ground stud and secure it by tightening the ground

nut.

12. Pull the slack out of the power cord through the side

of the contactor box and tighten the strain relief on

the contactor box.

13. Pull the slack out of the power cord through the

back of the unit and tighten the strain relief on the

outside of the unit.

14. Replace the cover to the contactor box.

15. Replace the back panel and left side panel.

Table of contents

Other Cornelius Beverage Dispenser manuals

Cornelius

Cornelius Drop-In Post-Mix Dispenser 2323 Universal User manual

Cornelius

Cornelius CTP-20 Setup guide

Cornelius

Cornelius VANGUARD 245 User manual

Cornelius

Cornelius Liquid Base Beverage Dispenser Owner's manual

Cornelius

Cornelius ED 300 BN User manual

Cornelius

Cornelius ED 300 BC User manual

Cornelius

Cornelius 1522 User manual

Cornelius

Cornelius Remcor TJ45-A User manual

Cornelius

Cornelius ED-250 User manual

Cornelius

Cornelius FlavorFusion Series User manual

Cornelius

Cornelius Profile 150 User manual

Cornelius

Cornelius Remcor TJ200 User manual

Cornelius

Cornelius Jetspray JT20 Setup guide

Cornelius

Cornelius IDC 255 PROGATE DRIVE THRU UNIT User manual

Cornelius

Cornelius MILLENNIUM MJ30-4 PB Manual

Cornelius

Cornelius Drop-In and Free-Standing Ice Cooled... User manual

Cornelius

Cornelius ED 300 BC User manual

Cornelius

Cornelius PRISM User manual

Cornelius

Cornelius IDC 255 User manual

Cornelius

Cornelius ED 300 BC User manual

Cornelius

Cornelius SFV1 Manual

Cornelius

Cornelius ED-250 User manual

Cornelius

Cornelius IDC 2 Series User manual

Cornelius

Cornelius Flavorfusion Ice Drink Dispenser with Flavor... User manual

Popular Beverage Dispenser manuals by other brands

PEGAS

PEGAS Evolution operating instructions

Ugolini

Ugolini MT micro Operator's manual

Bunn

Bunn SLCA-7 Installation & operating manual

Gekkeikan

Gekkeikan Sake Machine owner's manual

Olympia

Olympia DH709 Instructions for use

Marco

Marco ECOSMART PB10 instructions

Marvel

Marvel ML24BN Series Installation, operation and maintenance instructions

Cecilware

Cecilware 2K-GB-LD Catalog

Sure Vend

Sure Vend 673 Setup guide

Nostalgia Electrics

Nostalgia Electrics KEG7000SS instruction manual

Bunn

Bunn LCR-3 HV Installation & operating guide

Servend

Servend SV-200 manual 

EdgeStar

EdgeStar VBR440 owner's manual

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C user manual

Siemens

Siemens GA 3000 OPERATING & SERVICE MANUAL

Selbach

Selbach Fruit Juice dispenser operating manual

Taylor

Taylor C302NP Operator's manual

Vinotemp

Vinotemp VT-WINEDISP2 owner's manual