Comfort Maker Three Room Heat Transfer Kit
Components Included in this kit
• 1 x Mixed Flow 150mm Fan
• 5 x 3 metres 150mm Insulated Ducting
• 2 x Branch Take Offs
• 1 x Eggcrate Inlet Grille
• 3 x Adjustable Circular Outlet Diffuser
• Fittings & Fixings
5. Run and connect all ducting between the inlet grille, fan and outlet diffuser. Check
all joints are secure, duct tape is provided for this purpose. The system can now
be run on test.
6. Please Note: When connecting insulated duct to the spigots, you rst secure the
‘CORE’ to the spigot with duct tape. Then pull the ‘INSULATION’ up to the joint
and tape the ‘OUTER SLEEVE” to the spigot with the duct tape.
7. Use adjustable diffuser outlets to regulate the airow to each room. To adjust the
diffusers turn the cone clockwise to decrease the airow, anticlockwise to increase
the airow.
NOTE: This system does not generate heat. To ensure that heat is not lost through
our transfer system, your excess heat capacity in the source room, available for
transfer, must exceed the overall heat losses in the target room. The following points
are worthy of consideration, to optimise the performance of your system;
• Do you have enough excess heat?
You may need to run your heat source at higher output levels.
• Is your property well insulated?
Heat loss through poor insulation costs you money.
• Background heating takes time - Give the system time to create warm air
circulation through the house which may take several hours to establish.
IMPORTANT
• Switch off mains supply before making any electrical connections. If in any doubt contact a
qualied electrician
• This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience or knowledge, unless they
have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety.
• Young children should be supervised to ensure that they do not play with the appliance.
• If it is intended to install an air transfer system into a room where gas appliances are
used for the heat source, the gas re installation company must be consulted before
undertaking installation. Section G4/ 2.2 (Mechanical Ventilation) of the NZ Building Code
refers to certain safety criteria which should be considered when installing mechanical
ventilation in a room where gas appliances are used. The gas heating installation
company can advise on these aspects.
• Precautions must be taken to avoid the back-ow of gases into the room from the open
ue of gas or other open-re appliances when mounted in outside windows or walls.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualied persons in order to avoid a hazard.
• The fan is to be installed so that the blades are more than 2.1m above the oor.
SPECIFICATION:
Electrical: 220-240V ~50Hz
Fan Wattage: 70W
Airow Max: Low Speed: 420m3/hr
High Speed:560m3/hr
Max Temperature: 50°C
Sound Volume: 47 dB(A) 3m
See the list of ComfortMaker accessories overleaf
