Colorado time systems Dolphin Manual
Colorado Time Systems
1551 E. 11th Street, Loveland, CO 80537
Phone: 970-667-1000 x256 Fax: 970-667-1032 Toll free: 800-287-0653 ext. 256
www.coloradotime.com E-mail: customerservice@coloradotime.com
F911 Rev. 0707
Dolphin Wireless Stopwatch Timing System Set Up
Configure Software/Base
Connect base unit to laptop with USB cable. Open Hy-Tek Meet Manager, and open Dolphin
from the Interface menu on the Run screen. In the Dolphin interface, set the channel on the base
by clicking the Channel box and selecting the desired channel.
Configure starter:
TRIG = CTS for use with CTS electronic start system
TRIG = NC for use with a normally-closed electronic start system
Select CHAN to set channel number. The starter must be on the same
channel as the base.
(See How to Change Settings for details)
Configure lane watches:
Set LANE (1-10) and TIMER (A, B or C) for each watch.
Select CHAN to set channel number. All watches must be on the same
channel as the starter and the base.
(See How to Change Settings for details)
HOW TO CHANGE SETTINGS: Press and hold Reset and immediately press the Start/Stop
button. Hold them both until unit enters the menu. Release the Reset button and then the
Start/Stop button.
Press the Start/Stop button to change the setting for the current menu option.
Press Reset to advance to the next menu option.
Battery: 9-volt; provides 40+ hours of operation.
NOTE: When not in use, the Dolphin system should be stored away from the pool deck to
minimize corrosion.
Accessories and Replacement Parts
R-1004-0505 Base
R-1004-0506 Watch
R-1004-0507 Starter
R-015-569 USB cable
K-DSS-1 Kit- Starter to CTS Infinity start system
K-DSS-2 Kit- Starter to CTS Champ Start
R-045-011 Hard-sided carrying case (holds up to 27 devices)
ON/OFF: Press and
hold the Reset button to
turn watches and starter
on or off.
Electronic Start System
Synchronized Start/Manual Stop
Wireless Manual Start/Stop
Electronic Start System
Starts all watches
Starter
TRIG = CTS
Starter
Starts all watches
Starter
Lane watches
Lane watches
Lane watches
Start, stop and reset individually
Base unit
Receives information from
starter and lane watches
Base unit
Receives information from
starter and lane watches
Base unit
Receives information from
lane watches
Laptop
Logs information/
stores for Hy-Tek
Laptop
Logs information/
stores for Hy-Tek
Laptop
Logs information/
stores for Hy-Tek
Cable set (015-571) USB cable
USB cable
USB cable
Start Stop
Stop
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Patent Pending
Reset
Start Reset
Start Stop Reset
Other manuals for Dolphin
1
Other Colorado time systems Data Logger manuals
