Cleverscope CS1200 IsoPod User manual
Ken Henderson
Cleverscope
+34 644 38 14 28
2022-09-18
CS1200 IsoPod – User Guide
Introduction
The CS1200 IsoPod is a remote isolated digitizer Pod for the CS548 which allows measurement at higher isolation
voltage than the CS548 internal limit of 1kVAC CAT III or 2kVDC. It uses a standard QSFP terminated active optical
cable (AOC) to connect the CS1200 IsoPod to the QSFP remote sockets on the CS548 front Panel. The input
specification is identical to the CS548 internal channels.
This user guide shows how to connect and use the IsoPod. Please refer to the CS548 manual for full specifications.
CS1200 IsoPod
30kV isolation provided >150mm spacing between IsoPod and other structures.
2 pF free space capacitance >50 mm above reference plane
100 dB CMRR at 50 MHz
14 bit resolution, 100dB dynamic range
200 MHz Analog BW
100uV resolution on 0.8v range
200uV rms noise on 0.8V range
Two input ranges: +/-8V and +/-0.8V.
Batteries
The IsoPod uses 2x ‘21700’ size Li-Ion cells. These are normally delivered in a semi discharged state so please fully
charge before first use.
Note: The demo system is supplied with 4x 21700 5000mAh cells and 8-cell Li-Ion charger with USB type C adaptor.
Once charged insert 2 cells into IsoPod paying attention to the polarity as shown on the enclosure:
Then slide battery cover into place:
To open the battery cover press the button and pull on cover:
The supplied 5000mAh cells will run the IsoPod for approx 10 hours. At present we have not implemented battery
monitoring in the application so keep in mind the amount of time the IsoPod has been running. If the AOC is
removed the IsoPod it will go into a low power state extending battery life. However if the IsoPod will not be used
for some time it is best to remove the cells.
Fibre Optic Cable
The demo is supplied with a 3m long QSFP Active Optical Cable (AOC) but other lengths are available (5, 10, 15, 20,
25, 30 & 50m). Insert the AOC into the CS548 and IsoPod with the label facing upwards:
Plug in the AOC metal QFSP with the pull tab under the fiber. Use the pull tab right by the QFSP to push the plug in
until it clicks. To release pull on the plastic tab. DO NOT PUSH OR PULL ON THE FIBRE, OR THE STRAIN RELIEF.
Turn on the CS548. Once power up cycle is complete the IsoPod LED and enabled channel LEDs will be green:
Probing
The IsoPod is supplied with a stand placing it 65mm above the work surface. This will reduce the probe free space
capacitance and provide some isolation from ground planes. It is also supplied with a short x10 oscilloscope probe
fitted with a common mode choke. The aim is to damp the ringing of probe cable inductance and free space
capacitance of the IsoPod.
Probe tip can be fitted with a ground spring or a BNC adaptor. Keeping the ground inductance of the measurement
as low as possible is critical for achieving high common mode rejection.
The x10 probe will give a measurement range of +/-8V (0.8V input range) or +/-80V (8V input range). The IsoPod can
also be used with other standard oscilloscope probes or coaxial connections.
Application
The default setting is ‘INT’ for all channels. Click on the INT button to select REM for the remote IsoPod:
Table of contents
Other Cleverscope Test Equipment manuals
