Package Contents
Product Overview
Back View:
You should have received the following items inside of package:
- UPS Unit
- Quick Guide
- Communication cable
- Power cable (only for model)
Installation & Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that
nothing inside the package is damaged.
Connect to Utility and Charging
Connect the Loads
CAUTION: NEVER connect a laser printer or scanner to
the UPS unit. This may cause the damage of the unit.
Connect Modem/Phone/Network for Surge Protection
Connect a single modem/phone line into surge-protected “IN”
outlet on the back panel of the UPS unit. Connect from “OUT”
outlet to the computer with another phone line cable.
Options:
Backup
Surge Protect
AC Input
Circuit breaker
Modem/Tel/Network
USB Port
Front View:
6 hours
Connect Communication Cable
To allow for unattended UPS shutdown/start-up and status monitoring,
connect the communication cable one end to the USB port and the other
to the communication port of your PC. With the monitoring software installed,
you can schedule UPS shutdown/start-up and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by
pressing again the power switch.
Cold Start Function
When the UPS is off and there is no power utility, it's still possible to cold start the
UPS unit to power the loads.
Plug in the loads to output receptacles on the rear panel of the UPS.
Simply turn on the power switch of UPS unit, then devices connected
to the UPS will be protected by UPS unit.
Plug in the AC input cord to the wall outlet. For the
best results, suggest to charge the battery at least
6 hours before initial use. The unit charges its battery
while connecting to the utility.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has
adequate air flow. Please place the UPS away from other units at least
20 cm to avoid interference. Do NOT operate the UPS where the
temperature and humidity is outside the specific limits. (Please check the
specs for the limitations.)
1. Power switch
2. Normal mode
3. Battery mode
4. UPS fault
