4
SAFETY CONSIDERATIONS AND GUIDELINES
DANGER: DO NOT store or use gasoline or other flammable/explosive liquids/vapors in
or around the furnace.
DANGER: DO NOT operate the furnace if excess oil, oil vapors, or fumes have
accumulated in or around the furnace.
WARNING: DO NOT mix unapproved substances to the used oil supply, such as:
• Anti-Freeze
• Carburetor Cleaner
• Paint Thinner
• Parts Washer and/or Solvents
• Gasoline
• Oil Additives
• Chlorinated solvents
• Any other inappropriate / hazardous material
Instruct your personnel NEVER to add unapproved substances to your used oil. Burning
any unapproved substance will immediately void the furnace warranty and may cause
damage and unsafe operating conditions.
(1) The tank installation must comply with NFPA 30 and NFPA 31 fire codes.
(2) All oil lines must be constructed of copper, steel, or brass components. DO NOT use
rubber, plastic, or any other inappropriate material for oil lines.
(3) Be sure to follow all instructions for tank installation in the Owner’s Manual.
WARNING: To avoid serious injury or death, do not weld or allow open flames within 35
feet of the used oil supply tank.
Tank and Support Legs Assembly:
HEATING CENTER ASSEMBLY
(1) Refer to Figure 1
(2) Slide the four (4) 2” X 2” Vertical Posts through the channels on each side of the tank until
they rest on the floor. Having the vertical supports down on the floor will ensure the weight
of the furnace is properly supported.
(3) Place the Horizontal Supports across the top of the 2” X 2” Vertical Posts
(4) Install and tighten the twelve (12) set screws to secure all vertical and horizontal supports
(5) Fasten the Furnace Support Brackets to the Horizontal Supports with screws provided.
(Refer to Figure 2 which shows the area NOT to screw the Furnace Supports.)
