Canon F1N Camera User manual
Canon New F1
Instructions Manual
Lars Heineken
23rd December 2002
1
CONTENTS CONTENTS
Contents
1 Attaching the Lens 4
2 Battery 6
2.1 Loading the Battery .......................... 6
2.2 Checking the Battery .......................... 7
3 Shutter Release and Self-timer/Lock Lever 9
4 Holding the Camera 11
5 Focusing 12
6 Loading the Film 14
7 Setting the ASA/ISO Film Speed 15
8 Frame Counter 16
9 Exposure 18
10 Shutter 19
11 How to Choose a Shutter Speed 21
11.1 Freezing Motion ............................. 21
11.2 Blurring the Subject’s Motion ..................... 22
11.3 Panning ................................. 22
12 Aperture 23
13 Exposure Modes 25
13.1 Full-aperture Metering ......................... 25
13.2 Stopped-down Metering ........................ 26
14 Meter Mode Selector 27
15 Which viewfinder did you purchase? 28
16 Eye-Level Finder FN 29
16.1 Match-needle Metering ......................... 29
16.2 Stopped-down (Fixed-index) Metering ................ 32
17 AE Finder FN 33
2
CONTENTS CONTENTS
18 Aperture-priority AE 33
18.1 Stopped-down AE ............................ 35
18.2 Match-needle Metering ......................... 36
18.3 Stopped-down (Fixed-index) Metering ................ 36
19 Shutter-priority AE 38
20 Meter Coupling Range 41
21 Metering Sensitivity Areas 42
22 Exposure Compensation 45
23 Rewinding the Film 50
24 Depth of Field 52
25 Self-timer 54
26 Multiple Exposures 57
27 Exposure in Multiple Exposures 60
28 Flash Photography 61
28.1 AE Flash Photography with Speedlites 011A, 133A, 155A, 166A,
177A, 188A, 199A, 533G and 577G. .................. 61
28.2 Slow-sync Flash Photography ..................... 62
28.3 General Flash Photography ...................... 63
29 Shooting with Close-up Accessories 65
30 System Accessories 71
30.1 Canon AE Motor Drive FN ...................... 71
30.2 Canon AE Power Winder FN ..................... 72
30.3 Canon Film Chamber FN-100 ..................... 73
30.4 Canon Data Back FN .......................... 74
30.5 Canon Wireless Controller LC-1 .................... 75
31 Specification 76
3
1 ATTACHING THE LENS
1 Attaching the Lens
To remove the body cap, turn it counterclockwise until it stops and pull it off. To
reattach, align the red dot on the cap with the camera’s red dot. Then lightly push
the cap in and turn it fully clockwise.
Turn the rear lens cap in the direction of the arrow until it stops and pull it off. To
reattach, align the arrow on the cap with the lens’ red dot. Then lightly push the
cap in and turn it fully clockwise.
To mount the lens, align its red positioning point with the camera’s red dot and
turn the lens in the direction of the arrow until it stops and the lens release button
pops out. To remove the lens, turn it counterclockwise while pressing the lens re-
lease button.
CAUTION
Do not mount the lens if the red dot inside the camera mount and the red line
on the stop-down slide are showing. In this case, push in the stopdown slide so that
it locks in the normal (retracted) position and these warning marks can no longer
be seen.
4
1 ATTACHING THE LENS
The following lenses cannot be mounted on the New Canon F-1:
FL 19mm f/3.5 R 100mm f/3.5
FL 58mm f/1.2 R 100mm f/2
R 50mm f/1.8 FLP 38mm f/2.8
R 58mm f/1.2
Notes:
•Do not push the stop-down slide while advancing the film. Otherwise, it may
be impossible to mount the lens.
•Do not press the lens release button while mounting the lens or it may not
pop out, thus causing the lens to work incorrectly.
5
2 BATTERY
2 Battery
2.1 Loading the Battery
The action grip of the camera also serves as a battery chamber cover and therefore
must be removed to load a battery. To do this, press the release button and lift up
the grip.
Use one of the batteries listed below or an equivalent of another brand:
Lithium 6V Duracell PX 28L
Alkaline - manganese 6V Eveready (UCAR)
No. A544 IEC 4LR44
Silver Oxide 6V Eveready (UCAR)
No. 544,
Durqceli PX 28,
IEC 4SR44
To ensure proper contact, wipe the battery terminals with a clean, dry cloth before
loading. Load a new battery so that its terminals are in the directions indicated by
the diagram inside the battery chamber. Insert the negative end first, then push
down and insert the positive end. The camera will not function if the battery is
loaded incorrectly.
Then slide the action grip’s tab into the guide hole as shown, and lower the grip
until it locks in place.
6
2 BATTERY 2.2 Checking the Battery
2.2 Checking the Battery
The battery can be checked with the shutter dial at any setting other than ”A”, and
at any ASA/ISO film speed setting. With the shutter dial on ”B,” battery check is
possible only after the film has been advanced. To check the battery, press the check
button for about three seconds while looking in the viewfinder. Battery power is
sufficient when the meter needle is above the battery check index. The weaker the
battery, the lower the needle. However, even if the battery is weak, exposure will
still be correct as long as the shutter is released when you press the shutter button.
If the meter needle rests at or below the index, the battery is almost exhausted. In
this case, have a new battery ready.
With normal use the battery should last about one year. Battery po’wer may de-
crease, however, at temperatures below 0◦C (32◦F). In this case, load a new battery
and keep the camera warm until you are ready to shoot. Do not throw the original
battery away; keep it as a spare. Alternate the two batteries, keeping the one that
is not in use warm. Although a battery may not perfomm well in the cold, it may
work normally again at higher temperatures. Lithium batteries are recommended
for use at low temperatures.
IMPORTANT
The New Canon F- 1 can be used even if the battery fails simply by removing the
exhausted battery from the camera. The mechanically controlled shutter speeds are
1/2000 to 1/125 sec., ”S” (1/90 sec.) and ”B” (bulb).
Notes:
•Remove the battery if you do not expect to use the camera for about three
weeks or longer.
•Do not try to take the battery apart and never dispose of it in fire.
7
2.2 Checking the Battery 2 BATTERY
Try to make a habit of checking the battery at the followingtimes:
•After loading a new battery.
•If the shutter won’t function with the selftimer/lock lever on ”A.”
•Before and after making many long exposures at slow speeds other than ”B.”
•When you are using the camera at low temperatures.
•Before shooting important events.
•When the camera is used frequently.
•After storing the camera for a long time.
•Before going on a trip.
The battery check button also serves to cancel the self-timer, meter reading, illu-
mination of viewfinder information (”LIGHT” setting of meter mode selector), and
shutter operation during long exposures. The circuit is cancelled the moment you
press the button, and the second curtain will close when you remove your finger.
The shutter will not be released if you press the shutter button while pressing the
battery check button.
8
3 SHUTTER RELEASE AND SELF-TIMER/LOCK LEVER
3 Shutter Release and Self-timer/Lock Lever
The self-timer/lock lever of the camera has three settings. With the lever at ”A,”
press the shutter button halfway to activate the meter. To release the shutter, gen-
tly press the shutter button all the way down. When the level is at ”L,” the shutter
button is locked. It is advisable to turn the lock lever to ”L” when the camera is
not in use to prevent accidental shutter release and battery consumption. With the
lever at ”S,” the camera’s 10-second self-timer can be activated simply by pressing
the shutter button. For further details on self-timer photography.
Shutter release is electromagnetic as long as there is a battery in the camera. Once
the battery is removed, the camera switches to mechanical release, and only those
speeds which are mechanically controlled can be used. The shutter button has a
threaded socket in the center to accept a standard cable release.
IMPORTANT
The New F- 1 has a built-in safety circuit which prevents shutter release if the
lens aperture ring is on the ”A” mark and a power drive is not attached.
First push the advance lever out to its 30◦stand-off position To advance the film,
turn the advance lever all the way to the right in one continuous 139◦stroke or
several short ones. This also cocks the shutter and prepares the diaphragm and
9
3 SHUTTER RELEASE AND SELF-TIMER/LOCK LEVER
mirror for the next shutter release. The film must be advanced fully to the next
frame or the shutter will not release.
10
Other manuals for F1N Camera
1
This manual suits for next models
2
Other Canon Digital Camera manuals
Canon
Canon EOS 33 User manual
Canon
Canon PowerShot G7 X Mark III User manual
Canon
Canon PowerShot SX170 IS User manual
Canon
Canon WP-DC42 User manual
Canon
Canon PowerShot ELPH 130 IS User manual
Canon
Canon WP-DC28 User manual
Canon
Canon EOS 7D Mark II (G) User manual
Canon
Canon PowerShot S1 IS User manual
Canon
Canon Powershot S2 IS Instruction Manual
Canon
Canon PowerShot S30 User manual
Canon
Canon PowerShot A3300 IS User manual
Canon
Canon EOS 3 User manual
Canon
Canon DIGITAL IXUS 70 User guide
Canon
Canon 2756B003 User manual
Canon
Canon Digital IXUS 900 TI User guide
Canon
Canon IXUS 265 HS User manual
Canon
Canon PowerShot SD1200 IS Digital ELPH User manual
Canon
Canon DSLR User manual
Canon
Canon PowerShot SX60 HS User manual
Canon
Canon KP-36IP - Powershot A470 & Selphy CP780... User manual
