Candy CBT625/1X User manual

CBT625/1X

EN Instruction manual 2

PL Instrukcja obsługi 15

CZ Návod k použití 29

SK Návod na použitie 43

SL Priročnik z navodili 57

RO Manual de instrucţiuni 71

HR Uputstvo za upotrebu 85

BG Инструкция за употреба 99

CONTENT

1. General 3

2. Safety precaution 3

3. Warning 4

4. Installation instructions 6

5. Operation 8

6. Use and maintenance 9

7. Trouble shooting 12

1. General

Carefully read the following important information regarding installation,

safety and maintenance. Keep this information booklet accessible for further

consultations.

The appliance has been designed as a exhausting version (external exhaust )

or as a filter version (internal air recycle) cooker hood.

2. Safety precaution

Take care when the cooker hood is operating simultaneously with an open

fireplace or burner that depend on the environment and are supplied by

other than electrical energy, as the cooker hood removes the air from the

environment which a burner or fireplace need for combustion.

The negative pressure in the environment must not exceed 4 Pa (4*10-5

bar).

Provide adequate ventilation in the environment for a safe operation of

the cooker hood.

Follow the local laws applicable for external air evacuation.

3. Warning

This appliance can be used by children aged from 8 years

and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if

they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the

hazards involved. Children shall not play with the

appliance. Cleaning and user maintenance shall not be

made by children without supervision

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

The instructions shall state the substance of the following:

– there shall be adequate ventilation of the room when the

range hood is used at the same time as appliances burning

gas or other fuels (not applicable to appliances that only

discharge the air back into the room);

– the details concerning the method and frequency of

cleaning;

– there is a fire risk if cleaning is not carried out in

accordance with the instructions;

– do not flambé under the range hood;

– CAUTION: Accessible parts may become hot when used

with cooking appliances.

The installation instructions shall include the substance of

the following:

– the air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other

fuels (not applicable to appliances that only discharge the

air back into the room);

– the minimum distance between the supporting surface

for the cooking vessels on the hob and the lowest part of

the range hood. (When the range hood is located above a

gas appliance, this distance shall be at least 65 cm.

– regulations concerning the discharge of air have to be

fulfilled.

The installation instructions for range hoods with

accessible metallic enclosures of class II construction shall

include details that indicate the location and maximum

permitted lengths for any fixing or mounting screw or other

fixing device that penetrates into the range hood to attach

an accessory such as a facia or duct fitting.

Where fixing or mounting screws, or other fixing devices

are used, that penetrate into the range hood with an

accessible metallic enclosure of class II construction, to

attach an accessory, the instructions shall indicate the

required location of these screws or fixing devices and

include the substance of the following warning.

Warning: Failure to install the screws or fixing device in

accordance with these instructions may result in electrical

hazards.

4. Installation instructions

The cooker hoods should be placed at a distance of 65-75cm from the

cooking surface for best effect. （See Pic 1）

65cm

75cm

Pic 1

Way one: (See Pic 2A)

4.1.1 To install onto the wall drill 4 holes of Ø8mm on a suitable place

according with the centre distance of hole in the back of the cooker

hood.

4.1.2 Insert the wall plugs into the holes.

4.1.3 Insert the screws into the wall pulgs and tight the screws.

4.1.4 Put up the cooker hood onto the fixed screws.

4.1.5 Put the one air outlet and extensible pipe onto the cooker hood. (the

extensible pipe is optional not supplied)

Way two: (See Pic 2B)

4.2.1 Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard

4.2.2 Put the air outlet on the cooker hood, then install the cooker hood on

the bottom of the cupboard, tighten the hood with enclosed 6 screws.

4.3.3 Install the adjusted board on the bottom of the hood in order to keep

out the gap between hood back and cupboard.

5. OPERATION

5.1 Connect the plug into the power.

5.2 Push the switch ① into “ ”, the lamp be on; push into “0”, the lamp

be off.

5.3 Push the switch ① into “I、II”, the motor will be on “low、high” two

speeds, push into “0”, the motor will be off.

5.4 The cooker hood will working at low or high speed when pull out the

front panel.

6. USE AND MAINTENANCE

•It is recommended to operate the appliance prior to cooking.

•There shall be adequate ventilation of the room when the cooker hood is

used at the same time as appliances burning gas or other fuels(not

applicable to appliances that only discharge the air back into the room.

•It is recommended to leave the appliance in operation for 15 minutes

after cooking is terminated in order to completely eliminate cooking

vapours and odours.

•If the appliance is not used, please turn off.

•Don’t have flame under the cooker hood.

•Don’t use or stop use if the appliance is damaged especially the supply

cord and the case.

•If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualified persons in order to avoid a hazard.

•Don’t immerse the appliance in liquid.

•The exhaust air must not be discharge into a flue which is used for

exhausting fumes from appliance burning gas or other fuels.

•Regulations concerning the discharge of air have to be fulfilled.

•The details concerning the method and frequency of cleaning.

•In order to prevent fire hazard, it is recommendable to clean the filter at a

maximum of 2 months by carrying out the followings:

-Unplug before cleaning, then remove the filters from the cooker hood

and wash them in a solution of water and neutral liquid detergent,

leaving to soak.

-Rinse thoroughly with warm water and leave to dry.

-The filters may also be washed in the dishwasher.

•The aluminum panels may alter in color after several washes. This is not

cause for customer complaint nor replacement of panels.

•Clean the surface of the cooker hood regularly using cloth moistened

with denatured alcohol of non abrasive liquid detergent. (Remark: There

can not clear the motor and inside part.)

•Replace filters approximately every 4 months.

There is a fire risk if cleaning is not carried out in accordance with the

instruction.

Table of contents

Languages:

Popular Ventilation Hood manuals by other brands

emmeti

emmeti RECUPA MED A-140 Installation and use manual

Nibe

Nibe F135 user manual

Kuppersberg

Kuppersberg INTRO 60 Technical Passport

Zephyr

Zephyr Spruce AK9834BS Use, care and installation guide

Hisense

Hisense MH6INBG manual

Miele

Miele DA 1255 Operating and installation instructions

Broan

Broan 46000 Specification sheet

GE Profile PV977 Owner's Manual & Installation Instructions

FALMEC

FALMEC FFRIA24W5FS Instruction booklet

Whirlpool

Whirlpool RH2600XL-1 SERIES installation instructions

Küppersbusch

Küppersbusch DX ISLA instruction manual

ETNA

ETNA AV360RVS Instructions for use

JUNO

JUNO JDF603E6 installation manual

Miele

Miele DA 6708 D Operating and installation instructions

Tricity Bendix

Tricity Bendix LE 150 Installation & operating instructions

AEG

AEG X68163BV1 user manual

AEG

AEG 125 D operating instructions

Smeg

Smeg KSEV97X instruction manual