- Turn the crown backwards or forwards quickly.
The hands advance or retract the time by one
complete hour and the digital time display chan-
ges to match this new setting.
- Press the crown back down. The display sho-
wing seconds continues to flash. Press the
crown to set the time to the exact second (see
4.2.2).
Note:
Do not turn the crown in small increments after
turning it quickly in order to change the time zone
setting.
Changing the time zone
Whenever you change time zone or whenever
daylight saving changes occur between winter
and summer (and vice versa), you are able to
advance or retract the time shown by the hands
by anywhere between one and several hours
without losing the display showing the minutes
and seconds. To do this:
- Select and display local time.
- Pull out the crown. The numerals for hours and
minutes flash and the symbol T appears in the
dial.
13
You can only select one of these functions at
once, i.e. either SPLIT or ADD, but never both
at once.
- Starting and stopping the counter with conse-
cutive presses of the crown.
- In SPLIT mode, each time these operations are
repeated a new split time is indicated.
- In ADD mode, you can start and stop the counter
in quick succession.
- To reset the counter to zero, press the crown and
hold it down for more than 2 seconds.
- The maximum operational duration is 47 hours,
59 minutes and 59.99 seconds.
- While the chronograph is operating, it is possible
to select and use any other watch function at the
same time.
4.7 Using the chronograph
- Select the “Chronograph” function
(CHR) in SPLIT (SP) mode - for intermediate
times - or ADD (Ad) mode - for addition of
time.
14
4.8 Using the alarm
- Select the “Alarm” (AL) function.
- Pull out the crown. The numerals start
to flash.
H M S H
Time period > 1 hour and < 48 hours
- Hours - minutes - seconds
alternately with modes SP + hundredths
or Ad + hundredths
E.g.:
M S H
Timed period > 1 minute and < 1 hour
- Minutes - seconds - hundredths alternately
with modes SP or Ad
E.g.:
S H
- Return to the “Chronograph” (CHR) function
to stop the chronograph, read the time elapsed
and to reset it to zero.
If either of the modes ADD or SPLIT is selected,
the display shows the following information:
Timed period < 1 minute
- SP or Ad mode - seconds - hundredths
E.g.:
15
- To (de-)activate the alarm, press the crown after
first selecting the “Alarm” (AL) function.
AL display = alarm set (armed)
AL display = alarm not set (disarmed)
- Press the crown down to stop the alarm.
NB:
Since the watch can operate in either 12 hour
(AM-PM) mode, or in 24 hour mode, you must
bear this in mind when reading the time shown
for a second time zone (see 4.1).
Test of alarm
Press the crown and hold down for more than
2 seconds after first selecting the “Alarm” (AL)
function. The alarm will start to ring at this point.
- Display the desired time by turning the crown
forwards or backwards (one rapid rotation
changes the hours, and one slow rotation
changes the minutes.
Press the crown back down. The alarm is then
set, with AL showing on the display.
16
