INSTALLATION GUIDE
Actual product characteristics may vary. Bright Light reserves the right to improve, modify or update the product designs without prior notice.
ENCAPSULATED LED RIBBON | LITE
COLOUR CODE LUMENS
WARM WHITE
3000K BL-LS-4300-30 ≥180lm/m
NATURAL WHITE
4000K BL-LS-4300-40 ≥250lm/m
LED WATTS 7.2W/m
INPUT VOLTS 24V DC constant voltage
OPERATING TEMP. -25°C ~ +60°C
MAX. RUN PER
POWER FEED
15m using one feed
30m using two feeds
DIMENSIONS W6 × H12mm
(W8mm for connectors)
CUTTING LENGTH 50mm
MINIMUM BEND
RADIUS
10mm
BEND DIRECTION Horizontal bending
BEAM ANGLE 115°
SOURCE LIFE 50,000 hours
WARRANTY 3 years
INGRESS
PROTECTION
Protection established by use of
IP65 connections
CONTROL Dimmable by PWM signal
1. Cut Encapsulated LED Ribbon only
at the cut lines shown on Side A of
product.
2. To t an end or bottom connector, cut
out a notch (approx 3 × 3mm) from
Side B to expose the PCB solder
pads. Take care not to cut or damage
the PCB and LEDs in this step.
SIDE A
Cut mark are
visible on this side
SIDE B
When connecting cable,
notch out from this side
CUT OUT NOTCH TO EXPOSE SOLDER PADS
TOP VIEW - EXPOSE SOLDER PADS
CUT MARK
TOP / LIGHT DIRECTION
50
SIDE A VIEW - CUT MARKS CROSS SECTION
SIDE B VIEW - EXPOSE SOLDER PADS
1
2A
2B
3. Cut and trim the cable to the appropriate length and feed
through connector. Solder the wires onto the solder pads of the
Encapsulated LED Ribbon PCB ensuring the correct +/- polarity.
4. Insert silicone into connector before tting over connection. The
silicone is required to complete the IP65 rating. Failure to do this
will result in warranty becoming void.
5. Shortening ribbon / tting new end cap: Cut Encapsulated
LED Ribbon to length then t end cap and silicone in place.
SAFETY NOTES
– Before making any cuts, installation,
maintenance, or connection, be sure
the mains power is disconnected.
– All connector joints must be connected
correctly to achieve connector IP rating.
– Check the polarity of the connector
before inserting the front connector and
switching on the mains power.
– Cut and connect Encapsulated
LED Ribbon correctly. Any incorrect
operation can cause damage.
– Use a certied Bright Light 24V DC
power supply.
ENCAPSULATED LED RIBBON | LITE CAN BE CURVED AS SHOWN BELOW:
DO NOT TWIST THE LIGHT OR BEND AGAINST THE LIGHT SURFACE
CUT OUT NOTCH TO EXPOSE
SOLDER PADS
0800 952 000 | www.brightlight.co.nz | BRIGHTLIGHT
12
6
CUTTING RIBBON & CONNECTING BOOT CONNECTORS
ADD SILICONE
INTO CONNECTOR
BEFORE FITTING
SOLDER WIRES SILICONE CONNECTOR
34
BRIGHT LIGHT RECOMMENDS CONNECTIONS ARE MADE IN-HOUSE
LIGHT DIRECTION
HORIZONTAL BENDING
MINIMUM BEND RADIUS
10MM
