To note: console 10 being in this example the last console in BUS, this is why switch 8 must be ‘’ON’’. Only one
console can have higher priority on the others. Switches are ‘’ON’’ when they are down.
Once connected, switch ‘’POWER’’ of zone (1) upwards on ‘’ON’’.
To adjust the console volume (potentiometer in zone (3) above), follow the instructions below:
1) Test the Console by selecting a zone (to which speakers are connected) using the zone buttons (3) on the
front panel below
2) Press the `` CALL '' button (4) on the front panel below to trigger the chime and be able to speak (this allows
you to adjust the volume of the microphone in parallel according to the sound level received in the speakers /
this level is adjustable via the potentiometer (3) on the rear panel)
To speak in one or more zones from the console, you must:
1) Select the desired zone(s) with zone buttons (3) or all zones
with the button (5)
2) The LEDs of the selected zones then blinks in green (if LEDs are
staying in green permanently , it means zone(s) are busy)
3) Press the "CALL" button, the chime will trigger and then you
can speak (the ring on the microphone head also lights up in red)
4) Press the "CALL" button again to stop the broadcast
To note: If you prefer to maintain ‘’CALL’’ button to speak and
release it to end speaking then you can activate ‘’PTT’’ = ‘’Push To
Talk’’ switch on console rear, zone (5).
A 3.5mm Jack "AUX IN" input is also available on the rear panel (4). It allows you to broadcast a pre-recorded
message, for example via an external audio device such as a Smartphone. The operation for broadcasting is the
same as the one seen previously for speaking in one or more zones.
