3
IMPORTANT SAFETY INFORMATION
Please read this user manual before using this BBQ and keep it safe for future reference .
⚫Read the following instructions carefully and
be sure your BBQ is properly installed,
assembled and cared for. Retain the
instructions for future reference.
⚫Failure to follow these instructions may
result in serious bodily injury and/or
property damage.
⚫WARNING - Risk of Suffocation! BBQ’s must
be used outdoors and must not use in
enclosed areas such as sheds or marquees!
⚫Read the instruction manual before using the
appliance.
⚫WARNING: Accessible parts may be very hot.
Keep young children away.
⚫Wear heat proof gloves whilst operating the
appliance.
⚫This appliance must be kept away from
flammable materials during use.
⚫Do not move the appliance during use.
⚫Turn off the gas supply at the gas cylinder
after use.
⚫Do not modify this appliance.
⚫If you have any questions concerning
assembly or operation, consult the retailer or
Bottled Gas Company.
⚫Always place the appliance and cylinder on
flat level ground.
⚫Never light the appliance with the hood in
the closed position.
⚫Your BBQ can be used with gas cylinders
between 11 kg and 15 kg. The maximum size
is 310mm (Diameter) x 600mm(Height) .
Your BBQ will perform better if propane or
LPG mixtures are used. Butane can be used
but because of the power of this appliance
the cylinder may tend to freeze and supply
gas at reduced pressures affecting the
performance of your BBQ.
⚫The BBQ is supplied with a 27mm clip on
37mbar regulator. Alternative regulators may
be used as long as they are the correct rating
for the BBQ and type of gas used.
⚫When positioning the BBQ the following
clearances must be obeyed:
Sides and rear of appliance: 1 METRE
FROM ANY OBSTRUCTION.
Above the appliance: NO OVERHEAD
OBSTRUCTION ARE PERMITTED.
⚫Please turn off the gas cylinder if gas leak is
suspected.
⚫Parts sealed by the manufacturer must not
be altered by the user. No modifications
should be made to any part of this BBQ and
repairs and maintenance should only be
carried out by a registered Gas Safe service
engineer.
GENERAL INFORMATION FOR
SUCCESSFUL ASSEMBLY
Please read the assembly instructions carefully and follow the safety precautions. Allow sufficient time for
assembly. Before starting assembly, clear an area measuring approximately two to three square metres.
Remove the item from the packaging and lay out all of the parts and any necessary tools so that they are
within easy reach.
Only tighten all of the screw connections firmly when you have finished assembly or are instructed to
within the manual. Otherwise this can result in unwanted tension and instability.
