Bosch HMB402 User manual

IMPORTANT:

Local codes vary. Installation, electrical connections, circuit breakers

and grounding must comply with all applicable codes. Save these instruc-

tions for your local electrical inspector's use.

INSTALLER: Please leave these Installation Instructions with this unit for the

owner.

OWNER: Please retain these instructions for future reference.

WARNING: Disconnect power at the breaker before installing.

Please read this entire manual before proceeding

Contents

Step 1: Unpacking ............................................3

Step 2: Cabinet Preparation...........................4

Step 3: Electrical Installation..........................5

Step 4: Installing the Microwave Oven ...5

Step 5: Installing the Microwave Trim...........7

Step 1: Unpacking

A. Microwave Oven Model HMB

Open the box and carefully remove all fillers and packing material.

Your new Bosch microwave includes the following:

• Care & Use manual (1)

• Quick Guide (1)

• Warranty Card (1)

• Turn Table (1)

• Turn Table Support (1)

B. Trim Kit Models HMT

Open the box and carefully remove all fillers and packing materials.

Parts list:

• Trim Frame (1)

• Bottom Duct (1)

• Anti-tip Bracket (1)

• Side Duct (1)

• Upper Duct (1)

• Installation Instructions (1)

• Bottom Bracket (1)

• Screws #6

1/2" (13)

• Screws #8

1" (6)

• Template (1)

Trim Kits Microwave Ovens

30" cabinet HMT406 (Black) HMB406 (Black)

HMT402 (White) HMB402 (White)

HMT405 (Stainless) HMB405 (Stainless)

27" cabinet HMT476 (Black) HMB406 (Black)

HMT472 (White) HMB402 (White)

HMT475 (Stainless) HMB405 (Stainless)

Caution:

• Trim kits are designed for use only with the Bosch microwave oven models listed (See Table 1).

• For safety, do not alter or modify any part of this kit or oven.

Table 1

Step 2: Cabinet Preparation

Figure 2

• The cabinet cutout dimensions are shown in Fig-

ure 1.

• When the microwave oven is installed at the end

of a cabinet run, adjacent to a perpendicular wall

or cabinet door, it is a good practice to allow at

least

1/4"

spacebetweenthe sideof thetrim and

wall or door.

• Yourmicrowave ovencanbe installed intoacabi-

net or wall by itself or above any of the following

Bosch wall ovens:

HBL43, HBN/L44 or HBN/L74.

• Outletcanbelocatedanywherewithintheshaded

area as indicated in Figure 1.

Microwave

Cutout

Top of

microwave

shelf

3" minimum

}

Bosch

single wall

oven

cutout

Figure 1

Outlet should be

in the shaded area.

➛

14"

➛

➝

➛

Trim Kits Dimensions

Width (B) HMT40 28

-1

HMT47 25

-1

Height (A) All Trim Kits 16

-3

Depth (C) All Trim Kits 22

-3

" - 24"

Step 3: Electrical Installation

TheBoschmicrowaveovenisequippedwithagroundedcord. Thewallreceptaclemustbeinstalled

and grounded in accordance with the national electrical code. Also, electrical connections and

grounding must comply with all applicable local codes.

Theelectricalrequirementsforaseparatecircuitservingonlythismicrowaveovenare: 120V,60Hz,

15Amp.

Step 4: Installing the Microwave Oven

1. Disconnect the microwave oven from the outlet

before proceeding with installation.

2. Removeanylooseitems (turntable,support,etc.)

from the microwave oven.

3. Fasten the bottom bracket to the bottom duct

by using two 1/2" screws.

4. Install bottom duct with four 1/2" screws to

bottom of microwave.

Step A Front

Rear

1/2" Screws (2)

FRONT VIEW OF

MICROWAVE

Step 4: Installing The Microwave Oven (continued)

1. Remove the one existing screw from the left side of the microwave oven.

2. Connect the side duct to upper duct as shown.

a) Insert projecting tabs of upper duct into holes of side duct.

b) Bend tabs up as shown.

NOTE: Remove any oil or dirt on surface of microwave oven before ducts are attached.

3. Peel off the backing of double-sided tape. Attach

the side duct and upper duct assembly on the mi-

crowave cabinet. Press down firmly on ducts. Fas-

ten duct assembly to left side of cabinet with one

existing screw.

a) Upper Duct

3 tabs 3 holes

Side Duct

Existing

Screw

Step B

Step C

1. On the cutout floor, mark hole centers for the

anti-tip brackets as shown using the supplied

template.Besure to align the center lineoftem-

plate to center line of cutout floor.

2. Drill two holesfor anti-tip bracket. (Use 7/64" drill

or #35 drill)

3. Installanti-tip bracketontocutout floorusing two

1/2" screws.

DIMENSIONS:

A = 4-1/4"

B = 3"

C = 18-3/16"

Cutout FloorCenterline

1/2" Screws (2)

Anti-tip Bracket

Step 4: Installing the Microwave Oven (continued)

Step D

1. Slide microwave oven part way into cabinet

opening. (Bottom bracket must be flat to the

cutout floor to engage correctly with anti-tip

brackets as shown).

2. Plug in the microwave oven.

3. Center the microwave oven within the cutout

opening and slide the microwave oven in the

anti-tip bracket. (Ensure the microwave oven is

accurately centered.

4. Drill pilot holes (use 7/64" drill or #35 drill)

through the positioning flange and then install

three1/2"screws at thefrontofthe bottom duct

as shown.

1/2" screws Positioning

flange

Cutout

opening

Bottom

Bracket

1/2" screw

Anti-tip

Assembly

Bottom

Duct

Anti-tip

Bracket

1" Screw

Mounting

hole

Pilot

hole Cutout

Opening

Trim Kit

"A"

Figure Detail of "A"

1. Placethetrimkitframe overthe microwaveoven.

Important Note: Trim kit frame orientation is

important. Orient the frame

so the louvers are sloping

downward to the front. (See

Figure Detail A).

2. Make sure the trim kit is level and centered with

respect to microwave oven. Mark four hole cen-

ters through the four mounting holes of the trim

kit.

NOTE: Center the trim kit frame equally on all

four sides.

3. Removethe trim kitanddrill four pilotholes.(use

7/64 drill or #35 drill)

4. Attachthe trim kitframeby using four1"screws.

Make sure that the orientation is correct as

stated above.

5. Your trim kit is now fully installed. Replace

any loose items that have been removed from

inside microwave oven.

6. Pleasekeep thisinstallation instructionforfuture

reference.

Step 5: Installing the Trim Kit

Bosch reserves the right to change specifications or design without notice. Some models are certified for use in

Canada. Bosch is not responsible for products which are transported from the United States for use in Canada.

Checkwith your localCanadian distributor or dealer. Bosch,5551 McFaddenAvenue,HuntingtonBeach,CA92649.

For the most up-to-date critical installation dimensions by fax, use your fax handset and phone 702/833-3600.

Use code#8030.

BSH Home Appliances Corp.

Bosch Customer Support Call Center, 5551 McFadden Avenue, Huntington Beach, CA 92649 • (800) 828-9165

Other manuals for HMB402

This manual suits for next models

Table of contents

Other Bosch Microwave Oven manuals

Popular Microwave Oven manuals by other brands

Daewoo

Daewoo KOG-574R0S Service manual

LG MH7040SS instruction manual

Sharp

Sharp R-895(AL)M Service manual

Dometic

Dometic DOTRM13W installation instructions

Sanyo

Sanyo EM-X680 instruction manual

Sharp

Sharp R-393M quick start guide

KitchenAid

KitchenAid KMCX4510 Use and care

Smeg

Smeg S45MCX1 Instructions for use

Russell Hobbs

Russell Hobbs RHM2044 user guide

Sunbeam

Sunbeam SMW759 owner's manual

Gallet

Gallet FMOE230S instruction manual

Dometic

Dometic Roadmate 230 operating manual

Samsung

Samsung SJ0396W Owner's instructions

Sanyo

Sanyo EM-P494WS Supplement of service manual

Sharp

Sharp R-240 Operation manual

Electrolux

Electrolux EMS2840 user manual

Daewoo

Daewoo KOC-984T2S13 Service manual

Impecca

Impecca CM07M2 user manual