PROPANE GAS SAFETY
Your gas grill is designed to operate on
propane gas ONLY, at a pressure
regulated at 11” water column (W.C.)/
27.4 mbar when equipped with the
correct propane orifices on the valves
and a propane regulator.
Your propane gas grill is designed to
be used with a standard 20 lb/7 kg gas
cylinder. In the United States, the gas
cylinder must be constructed and
marked in accordance with
specifications of the US Department of
Transportation for Propane Gas
Cylinders. Outside the United States,
the gas cylinder must be approved
under CE NORMS: EN417 and test
code 215. Gas cylinder must be
constructed and marked with CE
regulations for the European country of
destination, where it will be used.
Always keep cylinder securely fastened
in an upright position.
Never connect an unregulated propane
gas cylinder to the grill.
Do not subject Propane cylinders to
excessive heat.
NATURAL GAS SAFETY
Your Natural Gas (when converted) grill
is designed to operate on natural gas
ONLY, at a pressure of 4” water column
(W.C.)/10 mbar regulated at the natural
gas regulator attached at the back of the
grill. Check with your gas utility for local
gas pressure and with your local
municipality for building code
requirements.
Check with your gas utility or with local
building codes for instructions to install
gas supply line, or call a licensed and
knowledgeable installer.
It is recommended that an “ON-OFF”
shutoff valve be installed at the gas
supply source:
-Outdoors after gas line piping exits
outside wall or before gas line piping
enters ground.
Pipe sealing compound or pipe thread
tape of the type resistant to the action of
natural gas must be used on all male
pipe thread. Apply compound or tape to
at least the first three threads when
making the connection.
Disconnect your gas grill from fuel
source when the gas supply is being
tested at high pressures. This appliance
and its individual shutoff valve must be
disconnected from the gas supply piping
system during any pressure testing of
that system at pressures in excess of 1/2
psig (3.5 kPa)/37 mbar.
Turn off your gas grill when the gas
supply is being tested at low pressures.
This appliance must be isolated from the
gas supply piping system by closing its
individual valve.
