Installation
This hood can be installed on the wall (as a wall hood) or
on the ceiling (as an island hood) according your needs.
The cooker hood must be placed at a minimum distance of
75 cm from the cooking plane for electric cookers and for gas
or mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
The hood is equipped with a top air outlet B for discharge
of fumes to the outside (Ducting version exhaust pipe
and pipe fixing clamps not pro ided).
Should it not be possible to discharge cooking fumes and
apour to the outside, the hood can be used in the filter
version, fitting an acti ated carbon, fumes and apours are
recycled through the top of the hood.
Expansion wall plugs are pro ided to secure the hood to
most types of walls/ceilings. Howe er, a qualified technician
must erify suitability of the materials in accordance with the
type of wall/ceiling. The wall/ceiling must be strong enough
to take the weight of the hood.
Preliminary information for installation of the hood:
Disconnect the hood during electrical connection, by turning
the home mains switch off.
Remo e the apour screens and the grease filter.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only.
Do not fix chimney flue to furniture or fly o er shel es unless
the chimney flue can be easily remo ed, in case maintenance
is e er required.
Installing the hood on the wall
1. Using a pencil, draw a line on the wall, extending up to
the ceiling, to mark the centre. This will facilitate
installation.
Draw two horizontal line: the first MUST correspond to
the lower side of the hood the second at 458mm o er
the first.
This last corresponds to the location of the upper hood
support fixing holes.
2. Rest the hood support bracket on the wall so that its center
coincides with the center ertical line, and through the
upper holes the upper horizontal line is isible, mark the
four outer holes and drill them, insert 4 wall plugs and
fix the hood support bracket into place using four screws.
3. Fix the lower bracket on the hood using two screws
(already in place).
. Fix the supplied hooks C on both side of the motor
housing (use two screws each hooks)
5. Hang the hood on the upper bracket.
6. Adjust the distance of the hood from the wall (use C
hooks).
7. Adjust the horizontal position of the hood (use C hooks).
8. Using a pencil mark the cooker hood permanent drill
holes on the lower bracket.
9. Un-hook the hood.
10. Drill at the points marked (Ø8mm).
11. Insert 2 wall plugs
12. Hook the hood again.
13. Fix the hood into its final position on the wall through the
lower bracket with two screws.
1 . Make all connections.
Replace the grease filter and the apour screen (snap into
place) and check that the hood is operating correctly.
Electrical connection
The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where pro ided, to the an easily accessible
outlet in conformity with local standards in force.
Where an electrical plug is not pro ided (for direct connection
to electrical network) place a standards appro ed bipolar
switch with an aperture distance of not less than 3mm
(accessible) from the contacts.
B
min. 50 cm
min. 75 cm
1458
mm
Y
Z
Y
Z
C
C
