Blueshape PG700E User manual
This symbol indicates the presence of an
electrical shock hazard. It is intended to avert
users not to open the product as there are no
user-serviceable parts inside. Any form of
servicing should be done by qualified service
personnel only.
ELECTRIC SHOCK
DANGER
This symbol is intended to alert the user
to important operating, servicing and
maintenance instructions within this product
manual.
This symbol is intended to alert the user to
the presence of uninsulated and potentially
dangerous voltage within the product’s
enclosure that may be of sufficient strength to
constitute a risk of electric shock to persons.
Explanation of symbols used in this manual
The contents of this operating manual are subject to change without
notice.
1
Read all instructions and cautionary
markings in this manual and on the power-
generator before using this product. Adhere
to these instructions to prevent misuse of the
products and possible injury or damage to
property.
Keep these instructions. This manual
contains important safety and operating
instructions for the PG700 power-generator
(the device).
DANGER
ELECTRIC SHOCK
General Safety Instructions
Warning
Earth the power-generator before using it as a power source to any
other device or equipment. To earth the power-generator, remove one
any of the four front-facing panel cap nuts and attach an earthing lead
with an M6 ring terminal. The other end of the earthing lead must be
terminated with:
- an earth rod inserted into the ground or
- a crocodile clip attached to a conductive earthed structure.
2
The equipment is being supplied with a
compatible AC mains power cord. In the
case when the UK plug is fitted, this plug is
equipped with a 13A replaceable fuse.
Damage to the power cord can lead to an
electric shock.
Danger
- Do not disassemble or modify the device.
- Do not discard the device into fire or heat.
- Do not leave the device near a heat-source such as a fire
or heater.
- Do not operate the device next to combustible gasses.
- Do not submerge the device in water or other liquid, whether
in operation or otherwise.
- Do not pierce the device with pointed or sharp objects.
- Do not strike the device with blunt objects.
- Do not subject the device to excessive mechanical shock.
- Do not use the device if it is apparently damaged or
deformed.
- Only connect mains plugs compatible with your device.
Warning
- If recharging operation fails to completed even when a
specified recharging time has elapsed, immediately stop
further recharging.
- Do not subject device to excessive micro-wave radiation.
- Do not subject device to excessive ambient pressures.
- Do not insert any objects into the device such as through its
ventilation.
- If the device gives off an odour, generate excessive heat,
becomes discoloured or deformed, or in anyway appears
abnormal during use, recharging or storage; disconnect it
and stop usage immediately.
- The operating temperature range is 0°C to 40°C. Operation 3
outside this temperature range may affect functionality and may
lead to damage to the device.
This device outputs voltages that can cause
injury or death.
ELECTRIC SHOCK
DANGER
DANGER
ELECTRIC SHOCK
4
The PG700 package contains the following:
- PG700 portable power generator
- AC power cord [according to region]
Device-End Connector: IEC 60320 C13
EU Plug: IEC 884/CEE7-VII3
UK Plug: BS1363A w/13A FUSE
US Plug: NEMA 5-15-P
- Operating Manual
Caution
- To reduce the risk of injury, close supervision is necessary
when this device is in use near children.
- Keep out of reach of children.
- Only use attachments recommended or sold by
manufacturer.
- Do not handle the device outlets or inlets with damp hands.
- Always place and operate the device on level ground.
- Only carry the device from the appropriate carrying handles.
- Do not operate the device with damaged power-cords.
Replace any damaged cords immediately.
- Do not obstruct ventilation - always operate the device with
the lid wide open.
PG700 Package Contents
5
Overview
The BLUESHAPE portable power generator is a Lithium-Ion (Li-Ion)
based alternating current (AC) inverter. The embedded Li-Ion battery
bank includes protection circuitry and electronics to ensure cell
longevity and product safety. This power-generator has an embedded
pure-sine wave inverter to generate clean and reliable alternating
current for substitute power when a mains supply is inaccessible or
interrupted. This is an all-in-one product, which also features built-in
charging capability.
The PG700 is built in a rugged portable hard case. When the lid is
closed for storage and handling; it can withstand shocks as well as
dust and water ingress.
Operational Modes
The device can operate in the three modes:
- Charge Mode
- Inverter Mode
- Online UPS Mode
PG700 Features
- Pure sine-wave Inverter
- Portable form factor with wheeled case
- Ruggedised construction
- IP67 enclosure for storage and transport
- Display with inverter and battery status
- Low-noise operation
- Integrated quick-charger
- Silent-charging
- 200W uninterruptible power supply
6
1
2
3
6
5
4
Graphic Description
Storage and Handling
The PG700 is constructed in a rugged hard-case and consists of the
following:
1. Telescopic Handle
2. Upright Carry Handle
3. Enclosure Lid
4. Roller Wheels
5. Lid Latches
6. Mid Carry Handle
7
1
2
3
8
4
7
5
6
Operation
The PG700 front facing panel consists of the following:
1. Exhaust Fans
2. Silent Charging Switch
3. Front Panel Cap Nuts
4. Charge AC Input Socket
5. Mains Outlet
6. Mains Output Switch
7. Intake Ventilation
8. Display
8
To charge the device:
1. Switch off mains output switch
2. Connect the provided IEC 60320
C13 lead into the socket labelled
‘charge in’.
Use silent charging only when necessary, cooling the
internal electronics during charging will ensure the
longevity of the device.
Operating Instructions
This section details the operational procedure for this power-generator.
The last sub-section details the different statuses, warnings and errors
shown on the display.
Charging the Device
Note: Charging will still work with the mains output active or idle.
Unless the inverter functionality is required, switch off mains output to
ensure pack longevity.
The display will show a charge progress bar and will indicate the
estimated time until fully charged.
To activate silent charging press the fan switch to the off position to
disable the fan during charging.
This manual suits for next models
1
Table of contents
Other Blueshape Portable Generator manuals
