The cord should be arranged so that it will not touch hot surfaces, sharp edges or drape over the
countertop or tabletop (where it can be pulled or tripped over unintentionally).
Outdoor extension cords should be used with products suited for outdoor use. They are surface marked with
suffix letters "W" or "W-A" and with a tag stating "Suitable for Use with Outdoor Grills".
To protect against electrical shock, the power cord and plug should be kept dry and off of the ground.
Do not clean this product with water spray; do not spray cleaners into the lamp socket area.
Gasoline, lighter fluid or other flammable liquids and vapors should never be stored in the area of this grill
or any
other grill.
Before installation or service, disconnect the power supply to the work area by removing the fuse, "tripping" the
circuit breaker, or unplugging the unit.
Keep any electrical supply cord and fuel supply hose away from any heated surfaces, sharp edges and dripping
grease.
Be certain your grill is properly installed and grounded by a qualified technician in accordance with
applicable
codes. To guarantee the electrical safety of this grill, continuity must exist between the
grill and an effective
grounding system. It is imperative that this basic safety requirement be met. The
manufacturer cannot be held
responsible for damages caused bythe lack or inadequacy of an effective
groundingsystem.
Do not operate any grill with a damaged power cord or power plug, and do not operate any grill after
the grill
malfunctions or has been damaged in any manner. If this should occur, return the grill to the
nearest authorized
service facility for examination, repair or adjustment.
Be certain your grill is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this grill, continuity must exist between the
grill and an
effective grounding system. It is imperative that this basic safety requirement be met. The
manufacturer
cannot be held responsible for damages caused by the lack of inadequacy of an effective
grounding
system.
This grill conforms to all uniform electrical safety codes and electrical grounding regulations. Install unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA70 or CSAC22.1 in their absence.
UNPACKING UNIT:
Your Blaze Series Grill comes pre-assembled and requires very little setup. We do however; recommend
the use
of professional help during the installation of your unit as improper installation may affect your warranty.
Remove
the unit from the box along with all accessories and check that no damage has occurred to the unit or
any parts.
Various parts of the grill are shipped with protective packaging and supports which will need to be simply
unpackaged and set in place. The charcoal crank is installed by screwing the threaded end into the opening on
the face of the grill.
Blaze Outdoor Products Instructional Book
Page | 7
Version 1.0
