BLACK DECKER BDCT450 User manual

BDCT450

2000W Hot + Cold Ceramic Tower Fan Heater

www.blackanddecker.co.nz

www.blackanddecker.com.au

THIS PAGE IS INTENTIONALLY BLANK

YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS

AND WARNINGS OUTLINED IN THIS MANUAL.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the

thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is regularly

switched on and off by the utility.

•This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities or lack of experience and knowledge, unless they

are supervised or have been given instruction concerning the use of the appliance by a

person responsible for their safety.

•Children should be supervised to ensure that they do not play with the appliance.

•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a hazard.

WARNING: You must not cover this heater. Covering this heater presents fire

risk and will activate the safety fuse, permanently disabling the unit.

WARNING: Do not use this heater in small rooms when they are occupied by

persons not capable of leaving the room on their own, unless constant

supervision is provided.

WARNING: To reduce the risk of fire, keep textiles, curtains, or any flammable

material a minimum distance of 1 metre from the air outlet.

•Use only the voltage specified on the rating label of the appliance.

•Keep all objects at least 1 metre from the front, sides and rear of the appliance.

•This appliance is intended for household use only and not for commercial or industrial use.

•Indoor use only.

•Use this appliance only as described in this manual. Any other use is not recommended

by the manufacturer and may cause fire, electric shock or injury.

•Do not use the heater if it has been dropped or damaged.

•The common cause of overheating is deposits of dust or fluff in the appliance. Ensure

these deposits are removed regularly by unplugging the appliance and vacuum cleaning

the air vents and grills.

•Always unplug appliance when not in use.

General Care and Safety Guide

•When the appliance has been unpacked, check it for transport damage and ensure all parts have been

delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team.

•Do not use if there are visible signs of damage to the heater.

•Never use the appliance to dry clothes.

•Do not connect the appliance to mains supply until completely assembled and adjusted.

•Ensure hands are dry before handling the plug or main unit.

•Ensure heater is on a flat, stable, heat-resistant surface.

•Do not operate with cord set coiled up as a heat build up is likely, which could be sufficient to become a

hazard.

•Carry out regular checks of the supply cord to ensure no damage is evident

•Do not operate this appliance with a damaged cord, plug or after the appliance malfunctions or has been

dropped or damaged in any manner. Return to a qualified electrical person for examination, electrical

service or repair.

•Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and

split. Always ensure that all cord has been removed from any cord storage area and is unrolled before

use.

•It is recommended that this heater is plugged directly into the wall socket. Power boards are not rated to

supply power to high wattage appliances.

•A correctly specified, undamaged extension cord may be used with this heater provided it is used in a

safe manner.

•Do not remove plug from power socket until the appliance has been switched off.

•Do not remove plug from power socket by pulling cord; always grip plug.

•Do not place cord under carpet or cover with rugs or furniture. Arrange the cord so it cannot be tripped

over.

•Don’t place appliance on bedding or on thick and long carpet where the openings may get blocked.

•Switch off and use handle provided when moving

•Do not place appliance close to radiant heat source.

•Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an

electric shock, fire or damage to the appliance.

•Do not sit on the appliance.

•Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in hot

soapy water only. Always remove plug from the mains supply before cleaning.

•Do not operate in areas where petrol, paint or other flammable liquids are used or stored.

•Do not use this appliance in the immediate surrounds of a bath, a shower, or a swimming pool or other

liquids.

•The appliance must not be immersed in any liquids.

•There are no user serviceable parts installed in the unit.

•Do not use the unit in wardrobes or other enclosed spaces as this may cause fire hazards.

•This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate

articles of science, etc are stored.

•If your appliance does not work, or is not working properly, contact the place of purchase or the Customer

Services Team.

General Care and Safety Guide

Components

Main Unit x 1

Remote Control x 1

Assembly

Assembling Method:

1. Take the machine out from the packaging

2. Carefully place the unit on a stable surface in an upright position

3. Remove all plastic packaging from the machine.

4. Locate the remote control before throwing the packaging away.

WARNING: Heater must not be used without base installed.

Base has been pre-installed by the supplier and is non-detachable.

The remote control supplied with this appliance uses a CR2032 coin type battery.

DANGER IF SWALLOWED

Keep batteries out of reach of children. Swallowing may lead to serious injury or

death in as little as 2 hours due to internal burns.

If swallowed, go straight to a hospital emergency room.

Dispose of used batteries immediately.

Operating your Heater

Always choose a safe location for the heater, keeping in mind the safety

precautions outlined. Ensure all packaging has been removed from the unit

before use. Please follow the below instructions.

WARNING: In order to avoid overheating or fire, do not cover the heater.

WARNING: Keep all objects at least 1 metre from the front, sides and rear of

the appliance.

WARNING: Do not use this heater with a programmer, separate timer, remote-

control system or any other device that switches the heater on automatically,

since a fire risk exists if the heater is covered or positioned incorrectly.

WARNING: Never leave this heater unattended.

Ensure heater is on a flat, stable, heat-resistant surface.

Once the heater is in a safe operating position and all switches are in the off position,

insert the power plug into the mains outlet and switch on.

CAUTION: Ensure the power cord is not tight because if pulled it may partially

pull the plug from the socket. A partially inserted plug will overheat the plug and

socket and could result in fire.

Note: When the appliance is turned on for the first time, it may release a slight odour or

smoke. This odour or smoke is a normal occurrence caused by the initial heating of the

internal heating elements and should not occur again.

Overview of Control Panel and Remote

CONTROL PANEL

REMOTE CONTROL

Power on/off

Timer Mode then

touch up/down icons

to select timer hours Oscillation/Swing

Heating Temperature

Selection Mode then

touch up/down icons

to select heating

temperature

Heating Mode. Also used to increase heating temperature and timer hours.

Cooling Mode. Also used to decrease heating temperature and timer hours.

Power on/off

Increase timer hours

Decrease timer hours

Select low heating mode

then touch again to select

high heat setting

Oscillation/Swing

Increase heating temperature

Decrease heating temperature

Select low cooling mode

then touch again to select

high cooling setting

HEATING MODE

Touch the icon to activate the low heating setting.

Another touch will activate the high heating setting

COOLING MODE

Touch the icon to activate the low cooling setting.

Another touch will activate the high cooling setting

OSCILLATION / SWING MODE

Touch the icon to activate the oscillation/swing function. Touch the icon again to turn it off

TIMER MODE

Touch the icon to activate the timer mode. touch the icon to increase the timer and

touch the icon to decrease the timer. Touch the icon again to confirm the timer.

The timer is a12 hour countdown timer.

ELECTRONIC THERMOSTAT (FOR HEATING MODE ONLY)

Touch the icon to activate the thermostat mode. Touch the icon to increase the

temperature and touch the icon to decrease the temperature. Touch the icon again to

confirm the temperature. When the room temperature reaches the preset temperature, the heating

function will cut off automatically. When the room temperature is lower than preset temperature,

the low or high heating will turn on automatically.

Operating your Heater

PROOF OF PURCHASE

To receive warranty retain receipt as proof of purchase.

Operating your Heater

SAFETY DEVICES

This appliance has two protection devices:

•Tilt Switch - this will automatically turn the appliance off if the appliance is not in the correct

operating position.

•Resettable Thermal Link - this will automatically disconnect the power to the appliance at a

pre-set overheat temperature. After cooling down it will reset and power on again. If this

occurs, investigate what is causing the appliance to overheat.

•Thermal Fuse - this disconnects the appliance permanently in case of overheating. (It is non

resettable).

CAUTION: The heater generates heat during use. Proper precautions must be

taken to prevent the risk of burns, scalds, fires or other damage to persons.

CARE AND CLEANING

•The heater requires regular cleaning to ensure trouble free operation:

•Unplug the heater from the mains supply before cleaning.

•Ensure that the heater has been allowed to cool down completely before cleaning.

•The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these

deposits are removed regularly by unplugging the appliance and vacuum cleaning the air

vents and grills.

•Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.

•Never use solutions such as petrol, thinners or polishing agents.

•Ensure the heater is dry before plugging back into the mains supply.

•Do not attempt to dismantle the appliance.

•There are no user serviceable parts. For service or repair, contact an authorised electrical

service technician

Table of contents

Other BLACK DECKER Heater manuals

BLACK DECKER

BLACK DECKER BXSH44005GB User manual

BLACK DECKER

BLACK DECKER BHDE1706 User manual

BLACK DECKER

BLACK DECKER BHDC500W46 User manual

BLACK DECKER

BLACK DECKER BHDT118 User manual

BLACK DECKER

BLACK DECKER BDCV350 User manual

BLACK DECKER

BLACK DECKER BHD101B User manual

BLACK DECKER

BLACK DECKER BXSH2000E User manual

BLACK DECKER

BLACK DECKER BHTC571 User manual

BLACK DECKER

BLACK DECKER HX310 User manual

BLACK DECKER

BLACK DECKER BXCSH1200E User manual

BLACK DECKER

BLACK DECKER BH1607 User manual

BLACK DECKER

BLACK DECKER BXSH1500E User manual

BLACK DECKER

BLACK DECKER BHVHC15 User manual

BLACK DECKER

BLACK DECKER OR070D-B5 User manual

BLACK DECKER

BLACK DECKER BXRA1500E User manual

BLACK DECKER

BLACK DECKER BXFSH2000E User manual

BLACK DECKER

BLACK DECKER BXSH2002E User manual

BLACK DECKER

BLACK DECKER BHVHC15 User manual

BLACK DECKER

BLACK DECKER BXWSH2000E User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide